“BEEN WORKING ON INSTALLING THE LEGS OR BASE FOR OVER TWO HOURS , I GIVE UP, NOT LINING UP.”
Answer This Question
1-10 of 12 Answers
Had to laugh. We had the same issue! Put them on a slant or diaganol and they will pop in. The ,3 screw holes throws you off. When you put it in diagonally, it looks off but when you stand it up it actually is a good design for stability. It took my daughter and I quite some time to figure it out!!
Sorry, there was a problem. Please try again later.The legs don’t on straight rather slanted also look at the legs they have R & L to let you know which is which.
Sorry, there was a problem. Please try again later.We’ll have I learned my lesson. ALWAYS read others QUESTIONS and ALL the ANSWERS BEFORE you tackle a job which normally is the easiest part of setting up a new TV. Thanks to finally, after 2 hours of trial and error putting the legs on the TV was a snap. I have 2 TVs, 2 hours on the first and less than 5 minutes on the second. Someone needs to write better instructions!!!!
Sorry, there was a problem. Please try again later.Use a magnetic screwdriver or you'll drive yourself crazy trying to line up the screws. Legs curve outwards, and they go at a more slanted angle than you'd think. They are labeled R and L. R goes on the right side when looking at the TV screen and L on the left. Mine were still wobbily the first time I put them in, so I took them off and tried again, alternating tightening the screws until they were really tight and the legs were finally firmly in place.
Sorry, there was a problem. Please try again later.After about 5 minutes trying to install the feet I checked the Best Buy web site questions and answers. There is a notch in the plastic on the top of the leg. Use it to fit the leg into the TV.
Sorry, there was a problem. Please try again later.Lining-up and tightening the tiny leg screws almost made me return the set. Almost need to be a watchmaker to do it easily. Great set for the money otherwise; but whoever designs legs for these TVS needs to think of an easier and sturdier way to get them installed.
Sorry, there was a problem. Please try again later.If you have the 75 inch the legs are near impossible to get on because the lock washer makes the screw seat crooked and it’s barely long enough to catch. Go to Home Depot and get M6x20mm for the 75 inch TV legs and they are the perfect length with no washer.
Sorry, there was a problem. Please try again later.I feel your pain. Nightmare trying to screw the legs on. This is for the NS-32F201NA23. 32inch. The initial alignment of the legs is easy but screwing them into place is not. You begin to wonder if you even have the right screws. 1) Set the legs aside and pre tread the screw holes. Screw the screws directly into the holes with some force. This took me some real elbow grease. Remove again. 2) Align each leg (L or R and with arrow pointing to front of TV) 3) Alternate between each of the two screws screwing a bit at a time (again with force) until each screw is finally all the way in and the leg is secure. 4) Take a nap!
Sorry, there was a problem. Please try again later.These piece of crap legs do not tighten up securely. Play in the legs make it very unstable. The tv will top over.
Sorry, there was a problem. Please try again later.We put a couple of small washers in and got it fairly stable. What an embarrassing horrible design.
Sorry, there was a problem. Please try again later.
