“Has anyone used this kegerator with Corney or Pepsi kegs? How easy or hard was it to convert? What was involved? Thanks!”
Answer This Question
1-2 of 2 Answers
Hi, We do not recommend to perform any type of conversion or modification in any of our units, this will void the warranty. Adolfo M. - Insignia Support https://www.insigniaproducts.com/contact-us
Sorry, there was a problem. Please try again later.To Signal20, I have the same kegerator and set mine up to use a standard 1/6 keg and a HOME BREW or “Corny” kegs. It is easy to convert to a “CORNEY” keg. There are 2 styles of corney kegs. They are either “BALL LOCK” or “PIN LOCK” styles. “BALL LOCK” are similar to an air hose chuck connection where you pull back a collar, push onto the fitting, and release the collar. For the “PIN LOCK” type, line up the slots, push on, and then twist to engage. The “BALL LOCK” type is more common. The beer line uses a 1/4” I.D. hose. The gas line uses a 5/16” I.D. hose. Install the fitting with the LARGER barb end to the GAS LINE. Cut off the fitting going up to the TAP and install the fitting having the SMALLER barb end. If using 2 corney kegs with DIFFERENT products, replace the fittings one at a time, identify that line "RIGHT TAP" or "LEFT TAP". Here are the components needed for the conversion of ONE CORNEY KEG. They are readily available from AMAZON. Good Luck. PERA Ball Lock MFL Quick Disconnects Set with Swivel Nuts (2) 5/16 Gas, 1/4 Liquid and clamp $11.95 PBT Pin-lock MFL keg quick Disconnect Set with Swivel Nuts (2) 5/16 Gas, 1/4 Liquid and clamp by PERA $11.99
Sorry, there was a problem. Please try again later.
