“Why is my drying light blinking, but cooling light solid, at the start of drying load? Shouldn’t the cooling light come on at the end?”
Answer This Question
1-1 of 1 Answer
The blinking drying light and solid cooling light at the start of a drying load on your Insignia™ 6.7 Cu. Ft. Electric Dryer with Sensor Dry might indicate an issue with the dryer’s sensor or control board. Typically, the cooling light should come on towards the end of the cycle, indicating the cool-down phase. Here are a few steps you can try to troubleshoot the issue: 1. Power Cycle: Turn off the dryer, unplug it from the power source, wait for about 30 seconds, and then plug it back in. This can sometimes reset the control board. 2. Check for Obstructions: Ensure that the lint filter and exhaust vent are clean and free of obstructions. Blockages can sometimes cause the dryer to behave unexpectedly. 3. Sensor Check: Make sure the moisture sensor inside the drum is clean. A dirty sensor can give incorrect readings, causing the dryer to malfunction. 4. Reset Settings: Try resetting the dryer to its default settings. Refer to the user manual for instructions on how to perform a reset. If these steps don't resolve the issue, it might be best to contact Insignia Support at 1-877-467-4289 for further assistance. I hope this helps! If you have any other questions or need further assistance, feel free to ask.
Sorry, there was a problem. Please try again later.