Questions & Answers

Q: QuestionIs the door reversible on this dryer?

• A:Answer Yes, the door is reversible to suit your laundry room layout.

Q: QuestionWhat type of electrical connection does this dryer require?

• A:Answer This dryer needs a 3- or 4-wire outlet for connection.

Q: QuestionWhat is the capacity of this dryer?

• A:Answer This dryer has a 6.7 cu. ft. capacity.

Q: QuestionDoes the dryer come with a power cord?

• A:Answer No, the power cord and vent kit are sold separately.

Q: QuestionHow many drying cycles does this dryer have?

• A:Answer This dryer has 12 unique drying cycles, including options like Delicates and Heavy Duty.

Q: QuestionWill Best Buy haul away your old Insignia dryer?

Asked 4 years ago by Debi.

• A:Answer I was told by best buy chat that for 30$ they will take your old appliance away.

  Answered 4 years ago by Alex

  Helpful (49)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionShown with door hinge on right. Can it be changed to hinge on the left?

Asked 4 years ago by EW.

• A:Answer Yes you can reverse the dryer door.

  Answered 4 years ago by InsigniaCustomerSupport

  
  Helpful (6)Unhelpful (1)ReportAnswer this questionShow more answers (3)

Q: QuestionIf I purchase the essential pkg including power cord and vent kit; can I expect that no matter what power cord I currently use/have with my existing dryer that this will work with the new dryer. and that I will have a working dryer when the tech leaves?

Asked 4 years ago by HolidayGift.

• A:Answer I purchased the essential pkg. But it ended up my stuff I had on old dryer worked just fine. So they reimbursed me for the essential pkg. And yes I would say you will have a working dryer. Mine does. And the two gentlemen that installed it where very good at their job.

  Answered 4 years ago by cleeVerified Purchase

  Helpful (9)Unhelpful (0)ReportAnswer this question

Q: QuestionIs that 120 voltage

Asked 4 years ago by Anonymous.

• A:Answer You can use the 3 prong power cable for 120 voltage and the 4 prong power cable for 240V.

  Answered 4 years ago by InsigniaCustomerSupport

  
  Helpful (30)Unhelpful (18)ReportAnswer this questionShow more answers (2)

Q: Questioncan you change the door so it opens the other way, from the right side

Asked 4 years ago by me.

• A:Answer If ordering from Best Buy have them change the door swing before delivery.

  Answered 4 years ago by Nomad

  Helpful (5)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionSince this does not have a rating,is it a new model?

Asked 5 years ago by Anonymous.

• A:Answer Yes

  Answered 4 years ago by nae30087

  Helpful (5)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionWhy is my drying light blinking, but cooling light solid, at the start of drying load? Shouldn’t the cooling light come on at the end?

Asked 1 year ago by ANicole.

• A:Answer The blinking drying light and solid cooling light at the start of a drying load on your Insignia™ 6.7 Cu. Ft. Electric Dryer with Sensor Dry might indicate an issue with the dryer’s sensor or control board. Typically, the cooling light should come on towards the end of the cycle, indicating the cool-down phase. Here are a few steps you can try to troubleshoot the issue: 1. Power Cycle: Turn off the dryer, unplug it from the power source, wait for about 30 seconds, and then plug it back in. This can sometimes reset the control board. 2. Check for Obstructions: Ensure that the lint filter and exhaust vent are clean and free of obstructions. Blockages can sometimes cause the dryer to behave unexpectedly. 3. Sensor Check: Make sure the moisture sensor inside the drum is clean. A dirty sensor can give incorrect readings, causing the dryer to malfunction. 4. Reset Settings: Try resetting the dryer to its default settings. Refer to the user manual for instructions on how to perform a reset. If these steps don't resolve the issue, it might be best to contact Insignia Support at 1-877-467-4289 for further assistance. I hope this helps! If you have any other questions or need further assistance, feel free to ask.

  Answered 1 year ago by InsigniaCustomerSupport

  
  Helpful (6)Unhelpful (2)ReportAnswer this question

Q: QuestionDoes it need special outs for hot air?

Asked 4 years ago by Gek.

• A:Answer Yes, this unit has a vent. Your dryer must be exhausted to the outside to reduce the risk of fire when installed any place inside the house.

  Answered 4 years ago by InsigniaCustomerSupport

  
  Helpful (4)Unhelpful (0)ReportAnswer this question

Q: QuestionWhere is the lint filter

Asked 5 years ago by Anonymous.

• A:Answer Bottom center when you open the door which opens to your right as you face the dryer

  Answered 4 years ago by AirneVerified Purchase

  Helpful (3)Unhelpful (0)ReportAnswer this questionShow more answers (3)

Q: QuestionDoes it come with a warranty?

Asked 3 years ago by Pam.

• A:Answer 1 year with manufacturer

  Answered 2 years ago by YJuiVerified Purchase

  Helpful (2)Unhelpful (0)ReportAnswer this questionShow more answers (2)

Q: QuestionHow makes insignia dryers?

Asked 3 years ago by Mark.

• A:Answer My understanding is they are made by GE Appliances, which is a division of Haier.

  Answered 3 years ago by BarryVerified Purchase

  Helpful (3)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionDoes the dryer come with a power cord?

Asked 3 years ago by Dee.

• A:Answer No. I have to buy my own power cord

  Answered 3 years ago by AnonymousVerified Purchase

  Helpful (1)Unhelpful (0)ReportAnswer this questionShow more answers (2)

Q: QuestionIs this dryer 110 volt?

Asked 4 years ago by Erica.

• A:Answer This dryer is 120V/240V (3 or 4 prong).

  Answered 4 years ago by InsigniaCustomerSupport

  
  Helpful (7)Unhelpful (4)ReportAnswer this questionShow more answers (1)

Q: Questionis the drum stainless steel?

Asked 4 years ago by wondering.

• A:Answer The drum is aluminum alloy coated steel.

  Answered 4 years ago by InsigniaCustomerSupport

  
  Helpful (2)Unhelpful (0)ReportAnswer this questionShow more answers (1)