“A once these are single voicecoil subs, can they be wired in parallel (2ohm) load and run on a bridged or mono amplifier?”

1-3 of 3 Answers

• Yes. Bridging it will give more power if in a sealed box not a ported box.

  Answered by EmilyW 3 years ago

  • Verified Purchase
  • 

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• Yes. I have a pair wired in parallel powered by a monoblock amp with a 1.8 final ohm load (voice coil resistance of each sub was actually 3.6 ohms as measured with a multimeter).

  Answered by gootz1977 3 years ago

  • Verified Purchase
  • 

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• If you have two of the same JBL GX 1200 4-ohm subs, yes, you can wire them in parallel to make a 2-ohm load. However, you must ensure that your amp can handle a 2-ohm load and deliver the wattage RMS required by the subs (250W + 250W = 500 Watts total RMS) at high to maximum bass levels. If you need more help, please contact our customer support.

  Answered by JBL Support 3 years ago

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.