“Just bought the kenwood 4 channel 600w had it all hooked up it’s lit up red on the amp but there’s nothing coming out of the door speakers, rem, G, power wire is all hooked up right.”
Answer This Question
1-2 of 2 Answers
There is two separate channels. One says A. and the other B. Make sure that the rca cables collated with the same side. I used all side A. Nothing on B. Im going to use B. For another set of highs. Also. Make sure you have the right rca plugs are in the right spot on the back of the radio. Also check the ground. You could be getting a false ground. Enough to turn on the amp but not enough power to push sound. Good luck.
Sorry, there was a problem. Please try again later.Hi , Well power light is a good sign amp is on, I ran my Kenwood amp to an aftermarket radio pluging RCA cables from the radio to the amp and connector the speaker wires to the amp also. Are you connecting amp to factory radio,,? Are you using a RCA Hi /Lo Audio Line Level speaker converter Adapter..?
Sorry, there was a problem. Please try again later.