Is it a standard 220 plug like this one? null

There are instructions for installing a 3-prong 240V cord in the manual. I think of four prong is preferred, but it's pretty easy to put the 3-prong on. I believe it's just moving one wire from the body to the middle ground prong.

You have to purchase the electrical cord separately. A standard 220 cord will. Work fine.

Yes in fact I reused the cord from the old washer.

The dryer should be connected to a 4-hole outlet. The dryer has its own terminal block that must be connected to a separate 240 VAC, 60-Hertz, single-phase circuit, fused at 30 amperes (the circuit must be fused on both sides of the line). Electrical service for the dryer should be of the maximum rate voltage listed on the nameplate. Do not connect the dryer to 110-, 115-, or 120-volt circuit. Use a 30-amp, 240-volt, 4-wire, UL-listed power cord with #10 AWG-minimum copper conductor and closed loop or forked terminals with upturned ends. ^Daphane

You install the dryer cord yourself, needs purchased separately

Ours was an installed 4 pin mobile home plug

“Is it a standard 220 plug like this one?”

This question is for: LG - 7.3 Cu. Ft. Electric Dryer with Sensor Dry - White

Asked by Plug 4 years ago

Answer This Question

See all questions & answers

LG - 7.3 Cu. Ft. Electric Dryer with Sensor Dry - Middle Black-Front_Standard

1-10 of 14 Answers

There are instructions for installing a 3-prong 240V cord in the manual. I think of four prong is preferred, but it's pretty easy to put the 3-prong on. I believe it's just moving one wire from the body to the middle ground prong.
Answered by JamesV 3 years ago
Sorry, there was a problem. Please try again later.
It uses a standard 220 plug.
Answered by MTELL 3 years ago
Sorry, there was a problem. Please try again later.
You have to purchase the electrical cord separately. A standard 220 cord will. Work fine.
Answered by BestBuyCustomer 3 years ago
Sorry, there was a problem. Please try again later.
Mine is 3 prong plug
Answered by DebbieF 3 years ago
Sorry, there was a problem. Please try again later.
Yes in fact I reused the cord from the old washer.
Answered by MrFixit 3 years ago
Sorry, there was a problem. Please try again later.
Yes
Answered by Dryer 3 years ago
Sorry, there was a problem. Please try again later.
The dryer should be connected to a 4-hole outlet. The dryer has its own terminal block that must be connected to a separate 240 VAC, 60-Hertz, single-phase circuit, fused at 30 amperes (the circuit must be fused on both sides of the line). Electrical service for the dryer should be of the maximum rate voltage listed on the nameplate. Do not connect the dryer to 110-, 115-, or 120-volt circuit. Use a 30-amp, 240-volt, 4-wire, UL-listed power cord with #10 AWG-minimum copper conductor and closed loop or forked terminals with upturned ends. ^Daphane
Answered by LG Digital Customer Care 4 years ago
Sorry, there was a problem. Please try again later.
You install the dryer cord yourself, needs purchased separately
Answered by FranklinY 3 years ago
Sorry, there was a problem. Please try again later.
Ours was an installed 4 pin mobile home plug
Answered by Jerry 3 years ago
Sorry, there was a problem. Please try again later.
Standard four blade plug
Answered by Amazed 3 years ago
Sorry, there was a problem. Please try again later.

1-10 of 14 Answers