“I have an Onkyo receiver. Switching zones requires tapping the zone button once for zone two and twice for zone 3. How do I get the remote to learn this? It's not recording the commands when I point the remote at the hub.”
Answer This Question
1-4 of 4 Answers
I am Utilizing a Onkyo receiver with this remote and using the app you can set up the Harmon Elete to do a series of functions with one button.
Sorry, there was a problem. Please try again later.You can create 2 separate activities - Zone2 and Zone3. Add a command in each that sends the same signal 2x or 3x in each activity. You can also switch your inputs, change audio signals, etc. in each activity.
Sorry, there was a problem. Please try again later.I'm the OP. I found some instructions. I haven't tried it yet. Basically, you need to add each zone as a separate device on the Harmony. https://support.myharmony.com/en-us/how-to-add-a-multi-zone-device#consumer Next thing I had to figure out, was setting the volume buttons on all devices to use the Receiver volume. This can be done by editing a button.. Take some digging trough the settings to get to it.
Sorry, there was a problem. Please try again later.You ask an excellent question and frankly I am still in a "learning mode" for myself with this new remote. Still, I know what you are asking and frankly I don't think it has the capability to accomplish your task. As I understand, it has no "micro memory" like some higher end Universal remotes have. I wanted a long delay before it lowered the lights in my theater room and such was not possible. Understand I am not "putting down" this Elite remote. It does all the task listed in the info provided and I bought it for that reason.
Sorry, there was a problem. Please try again later.