“The depth dimension described is approx. 33" front to back. Is there a clearance dimension from back of the washer to the wall that must be maintained?”
Answer This Question
1-3 of 3 Answers
You can put the back of the the washer up against the wall. The 33 inches is from the lower bottom on the back of the washer to the front. There is a hump in the lower bottom of the back of the washer that tapers to a flat back near the top of the washer. This give a small area that you can route your water lines or accommodate hot and cold valves on the wall.
Sorry, there was a problem. Please try again later.Yes clearance is needed. I'd estimate you need 3-4 inches clearance to allow room for the fill hoses and drain hose at the back of the washer.
Sorry, there was a problem. Please try again later.Hi Jack, please click on the link below to view the installation instructions and reference page 3. Thank you for your inquiry regarding our Maytag appliances! https://bit.ly/2mQkI74
Sorry, there was a problem. Please try again later.
