“How do I install the gpu bracket that came with the card?? It was not listed in the directions and there is nothing that I can find online about it. Just was hoping to eliminate gpu sag.”
Answer This Question
1-8 of 8 Answers
Oh yeah that GPU bracket is a pain to install, over-sized, and is half worthless as it only helps the sag and can't alleviate it. Buy 2 extra braces aftermarket and your good to go. Did my best to install the original that it shipped with like I said that thing is half worthless.
Sorry, there was a problem. Please try again later.You screw the brace in next to the card. You leave the PCI slot plates there, remove the screws, insert brace, and reinstall the screws. The screws go through both the brace and the slot plates, holding them both in place. You want to have to have the brace just barely touching the card to start with. If the GPU starts to sag, it will apply more pressure to the brace, which will push back against the GPU and keep it from sagging.
Sorry, there was a problem. Please try again later.The two ridges on top of the bracket slot into the edge of the card. as you slot them in, you plug the brace into the two pci slots aligned with the brace. Screw in the screws, into the end of the brace, you took out to access the two pci slots. Having said that, I would not use the brace. It is ugly as all get out. You should be fine without the brace, if you socket your video card in correctly, and screw in the pci slot connectors.
Sorry, there was a problem. Please try again later.You mount the bracket in the next two slots below the GPU support screws on your case. After you snap the card into the pcie slot, and you tighten the screws to support it in your case, you mount the bracket to the next two screws below that.
Sorry, there was a problem. Please try again later.It installs in the case slot under the gpu. Just screw it in and allow it to apply slight pressure to the card. Theres an instruction guide with the bracket.
Sorry, there was a problem. Please try again later.Place the bracket in the slots right under the card and tighten down
Sorry, there was a problem. Please try again later.Very easy to install. It installs in the next slot on the case and acts as a support. Instructions that come with the card show you how to do it.
Sorry, there was a problem. Please try again later.It's already installed just check the screws.
Sorry, there was a problem. Please try again later.
