Is there any way to adjust the delay when the camera starts on motion? A lot of recordings have no movement in them because of the delay of the camera starting, also it just records for 10 seconds, even when there is constant movement longer than that, is there a way to extend recording time.

Question

BWilhelm · Accepted Answer

Under 'mode', you can define a mode (basically a set of rules) and define or edit the rules around each camera. When you define a rule for a camera (for example your front driveway camera), you can set it so that if it detects motion, it should record for x amount of seconds and set you an email and/or push notification. The default recording time is 10 seconds I believe. I set mine to 30 seconds, which seems to be enough to capture most activity.

Answered by BWilhelm 9 years ago

TH1Racer · Answer

Yes, the latest firmware has an option up to 2 min due to it being run on batteries ! Lag time is around 20 sec these days. This means that even tho there is motion IE an intruder after the 2 minuets it stops takes 20 ish seconds to reload and start recording again.... You can miss alot in 20 seconds....

Answered by TH1Racer 9 years ago

JmiBobWC · Answer

Yes. Go to modes, record and slide the bar up to longer time.

CommunityAnswer · Answer

Yes, the delay can be adjusted.

“Is there any way to adjust the delay when the camera starts on motion? A lot of recordings have no movement in them because of the delay of the camera starting, also it just records for 10 seconds, even when there is constant movement longer than that, is there a way to extend recording time.”

1-4 of 4 Answers