“Just hardwired the cable. They did not run the battery wire straight to the batter but to something in my fuse box that constantly has power 12volts. When in parking mode it doesn’t appear that it is charging or staying on to record. What should I do?”
Answer This Question
1-4 of 4 Answers
The connections should be as follows. One to the ground, any ground will do. One to the battery. And one to something switched. The reason is that once you turn your car off, the switched power cuts out. That is what triggers the parking mode. You can set the voltage cut out by opening the device and changing the jumper. But u must have that battery wire hot at all times. Otherwise it will not work properly.
Sorry, there was a problem. Please try again later.Make sure to turn the Parked Recording Mode ON, here are the instructions: http://bit.ly/2nc5bBP Also to record parked videos, you must connect your camera to the Dash Cam parking mode cable accessory. If you need assistance, Garmin Product Support would be happy to help. Our contact information, including telephone number and hours of operation, can be found on at: https://support.garmin.com/en-US/
Sorry, there was a problem. Please try again later.Make sure you go into the Dash Cam menu - while connected and powered by the parking cable - and turn on Parking Mode
Sorry, there was a problem. Please try again later.If its NOT Geek Squad who installed it good luck, to be safe have Geek Squad inspect it the only cost is your time. IF they installed it and you have this question notify mangement this is not their SOP.
Sorry, there was a problem. Please try again later.