“Can you cut the strip in 2 and still use both of the strips you cut?”
Answer This Question
1-10 of 14 Answers
NO YOU CANNOT.. once you cut it, you're done with the end you cut off. There are marks WHERE you can cut, but the piece cut off is trash.. They also sell 3' extenders you can add to the standard 6' strips. But at the cost, I'd avoid cutting anything.. $90 a pop is a lot of money to throw away..
Sorry, there was a problem. Please try again later.Yes, you can, but it will require soldering wire to connect the strips together. Videos exist on the internet showing you how to make this possible.
Sorry, there was a problem. Please try again later.Strips can be cut at certain spots along it. However, the power comes from one side, so you cannot just "plug in" the other end to an outlet. You could add it to a shorter length though to extend it, i think.
Sorry, there was a problem. Please try again later.yes you can cut and splice any led strip by either soldering or using led splice kits that you can find on amazon.
Sorry, there was a problem. Please try again later.No, that would require 2 adapters to power and connect to the bridge, strips can be extended with a kit or made shorter by trimming
Sorry, there was a problem. Please try again later.No. You will only be able to use the strip that's connected to the plug. The other side doesn't have an electric source so it's no longer usable.
Sorry, there was a problem. Please try again later.If you cut the Philips Lightstrip on the side connected to the power supply will be usable.
Sorry, there was a problem. Please try again later.Unfortunately, no you cannot use both ends that have been cut. The only end that you can still use is the one with the power supply connected to it.
Sorry, there was a problem. Please try again later.No. After you cut the light strip, the only end that will work is the one with the power connector.
Sorry, there was a problem. Please try again later.Yes, but you have to solder them to a run with the power. You can extend with just about any low voltage cable (I user cat5). This allows me to make parallel strips with little "Jumpers". If you've never soldered before, then don't start here...but even a novice who knows what tinning is can do this...it is low voltage after all. Just look at the "cut lines" and you will see solder pads you can use on both sides.
Sorry, there was a problem. Please try again later.