Questions & Answers

Q: QuestionWhat is the minimum frequency response for this speaker?

• A:Answer The minimum frequency response for this speaker is 35 hertz.

Q: QuestionAre there any featured streaming services supported by this speaker?

• A:Answer Yes, this speaker supports Apple Music as a featured streaming service.

Q: QuestionWhat is the impedance of this speaker?

• A:Answer The impedance of this speaker is 4 ohms.

Q: QuestionIs speaker wire included with this speaker?

• A:Answer Yes, speaker wire is included with this speaker.

Q: QuestionWhat is the peak power handling of this speaker?

• A:Answer The peak power handling of this speaker is 200 watts.

Q: QuestionHow many woofers are included in this speaker?

• A:Answer There are two woofers included in this speaker.

Q: QuestionThe specifications say in two spots that this speaker only hands 25 watts continuously. Is this correct or this that a typo? How can a speaker be rated with only 25 watts? I've never seen any A/V Receiver that weak. My A/V Receiver sends 145w per channel

Asked 3 years ago by MichaelZ.

• A:Answer Hi MichaelZ, The rating of 25 watts refers to the recommended minimum wattage rating of an amplifier to be used with these speakers. While your receiver may be capable of producing 145 watts per channel, it is unlikely to ever do so. The wattage amount produced by an amplifier is determined by the speaker it is partnered with, and the volume level selected by the equipment user. Most modern speakers are pulling little more than 20 watts per channel from their partnering receiver/amplifier when playing quite loud in a regular domestic setting.

  Answered 3 years ago by Polk Audio

  
  Helpful (9)Unhelpful (1)ReportAnswer this questionShow more answers (1)

Q: QuestionI have the XT70s, XT30, XT90s. I noticed on s55 they have 2 speaker wire connections but XT70 doesn't, can I wire the XT90s (heighten speakers) together with 70s? have Onkyo 7 channel now, with rear XT20s (old version). hope this makes sense, thanks

Asked 4 years ago by BrianC.

• A:Answer No, should be hooked up to the surround speaker on the avr receiver. (front height) or (surround) on back of receiver.

  Answered 4 years ago by BurnerVerified Purchase

  Helpful (3)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionWhich are better for music ? Especially if you have hearing deficiency in high range. The XT 70 or s55 towers ? Which are the best ones for music only regardless ?

Asked 4 years ago by BigDave.

• A:Answer Hello, the Polk Audio S55 should prove to be the better choice. S55 speakers are a more refined speaker providing a cleaner musical playback experience.

  Answered 4 years ago by Polk Audio

  
  Helpful (4)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionIs this the price for a set of two? Thanks

Asked 4 years ago by Flo.

• A:Answer no

  Answered 4 years ago by BurnerVerified Purchase

  Helpful (3)Unhelpful (0)ReportAnswer this questionShow more answers (2)

Q: QuestionWhat is the recommended speaker wire size for these large speakers?

Asked 3 years ago by Enthusiast.

• A:Answer For average speaker wire runs (5-15 ft), a 14-gauge wire will work perfectly fine. 15+ ft, consider 12-gauge wire.

  Answered 3 years ago by Polk Audio

  
  Helpful (2)Unhelpful (0)ReportAnswer this questionShow more answers (2)

Q: Questioncan i use these with a 6-8 ohm receiver

Asked 4 years ago by Rhocala43.

• A:Answer Yes, XT70 speakers can be used with an AV receiver outputting 6-8 ohms.

  Answered 4 years ago by Polk Audio

  
  Helpful (2)Unhelpful (0)ReportAnswer this questionShow more answers (3)

Q: QuestionCan I use these 2 Tower Speakers XT70 with Yamaha Mixer MG10XU only?

Asked 2 years ago by Tango25.

• A:Answer Hello, A mixer alone will not be able to deliver a signal powerful enough to drive passive speakers such as the XT70. For this to work, you would need an external amp to take the signal the mixer is summing via the Stereo Out then amplify it to the speakers. While this is possible to do, please note this is not an intended use for these speakers and over driving them may cause damage to the speakers.

  Answered 2 years ago by Polk Audio

  
  Helpful (1)Unhelpful (0)ReportAnswer this question

Q: QuestionIs this priced at a pair?

Asked 3 years ago by Anonymous.

• A:Answer No it’s priced each

  Answered 3 years ago by WJ12Verified Purchase

  Helpful (1)Unhelpful (0)ReportAnswer this questionShow more answers (3)

Q: QuestionCan I run a pair of Polk Audio XT70’s with my Sony STR DE135 receiver?

Asked 5 months ago by StuartB.

• A:Answer Hello, your Sony receiver will adequately power the Polk Audio XT70 speakers.

  Answered 5 months ago by Polk Audio

  
  Helpful (0)Unhelpful (0)ReportAnswer this question

Q: QuestionAre these speakers sold as a pair

Asked 8 months ago by icymountians.

• A:Answer Yes

  Answered 7 months ago by MellowVeloVerified Purchase

  Helpful (0)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionHi what is the size of mid range speakers and bass radiators screws and what size of hex key i will need

Asked 1 year ago by goran2099.

Q: QuestionIs the XT70 a 3 way speaker?

Asked 1 year ago by Jcen20.

• A:Answer Hello, the Polk Audio XT70 speakers are a two-way design. The eight-inch drivers are passive bass radiators.

  Answered 1 year ago by Polk Audio

  
  Helpful (0)Unhelpful (0)ReportAnswer this question

Q: QuestionIs the Denon AVR-S650H enough power to run the speakers?

Asked 2 years ago by Dave.

• A:Answer Hello. Yes - Denon's AVR-S650H is comfortable driving Polk Audio's XT70 speakers.

  Answered 2 years ago by Polk Audio

  
  Helpful (1)Unhelpful (0)ReportAnswer this questionShow more answers (1)