“I got this one but I didn't understand the setup directions and now I have lost them. Can you help. I have a Sylvania dtv HDMI with Dolby sound”
Answer This Question
1-2 of 2 Answers
Any OTA (over-the -air) antenna is easy to install. Just hook up the antenna coax to the back of the tv. You should have a coax connection marked antenna in or atsc. Next go to your set-up "settings" > set to TV or antenna> scan "all channels" > this takes about 10 minutes > your TV will tell you when it is done > newer TVs tell you how many channels you get and the strength of the signal on each station. If you need to keep the antenna farther away from the TV buy more coax and a joiner from Best Buy. The only bad part about OTA is no TV guide like cable stations have. GOOD NEWS IS THE PICTURE IS MUCH CLEARER BECAUSE CABLE COMPANIES COMPRESS THE SIGNAL!!!! There are digital recorder boxes that can be joined with OTA shows. AND there are stations that you cannot get with cable. Good luck- it is easy to set up!!! And you save a lot of money!!!!
Sorry, there was a problem. Please try again later.The setup is super easy. All TV have ANT port in the rear. Just plug the antenna coax cable in and rotate the connector until it is fully fastened. Remember to be gentle or you may end up bending the inner center pin. Once connected, search for TV settings, look for Antenna and then start Scanning for the channels. Please ensure that this antenna is stretched closer to a window, this will make signal reception better. Once scanning is complete enjoy the free TV.
Sorry, there was a problem. Please try again later.