“I have the HW-650A sound bar and SWA-9100S rear speaker kit. Does not connect automatically. Sound bar does not show "GET ID" or anything by pressing the UP button on the remote. Service only says do the same thing with same result. How do I return it?”
Answer This Question
1-2 of 2 Answers
The process for connecting the wireless speakers wasn’t that bad for me. I noticed that while the Wireless Receiver Module is in the ”LINK” mode, blue LED indicator blinks you had to power off the sound bar first then press the “Up” button on the Soundbar remote control for 5 seconds. If you don’t do this correctly, you have to start the process again. The “ID SET” message will appear on the Soundbar’s display for a short period of time and then disappears. After that, the Soundbar power will automatically turn on and the LED will stop blinking and glows a solid blue when a connection is established between the Soundbar and the Wireless Receiver Module. If the process fails with a “Red” LED on the Wireless Receiver Module, check that the Soundbar is turned on and press the ID SET button on the back of the Wireless Receiver Module with a pen tip for about 5~6 seconds until the LINK LED indicator blinks blue again then start the link process again. I hope this helps.
Sorry, there was a problem. Please try again later.Hi! I am sorry to hear about the issues you experienced with the connection of your rear speakers. For information on returns, please visit or contact your local Best Buy. ^Tim
Sorry, there was a problem. Please try again later.