“I can not get the rear speakers to work. I've tried just about everything I can think of?”
Answer This Question
1-2 of 2 Answers
It was really tricky for me to get them to work as well. Make sure the speaker wires are not pushed too far in the connection on the speakers. Second I had to use the app to get them to work at first. Third, the setting on the sounds bar needs to be set to the correct output.
Sorry, there was a problem. Please try again later.Hi Josh! Here are some instructions on how to pair the rear speakers included with your HW-Q850T soundbar: - Connect the speakers' wires to the wireless receiver. To do this, insert the gray plug into the gray jack on the wireless receiver. Then, insert the blue plug into the blue jack on the wireless receiver. - Attach the cables to their corresponding speaker. Match the gray cable to the speaker with the gray label on its back, and match the blue cable to the speaker with the blue label. - Insert the red and black ends of each speaker wire into the corresponding red and black terminals of the appropriate speakers. *Note: Make sure the clamp is directly on the stripped wire portion and not on the insulation, for a proper connection. - Plug one end of the wireless receiver's power cord into a power outlet, and then connect the other end to the wireless receiver. - If the LED indicator light is blinking, you'll need to perform an ID SET on the soundbar to connect it: Turn off the soundbar using its remote or by pressing the Power button on the soundbar itself. - Press either the VOL button or the Up button on your soundbar's remote. Hold down the button for 5-6 seconds until the “ID SET” message appears on your soundbar’s display. *Note: Which button you need to press varies by model. Please read your soundbar's user manual for specific instructions. - Turn the soundbar back on using its remote or by pressing the Power button on the soundbar itself. Some soundbar models will automatically power on after completing the "ID SET" steps. - The LINK LED indicator will stop blinking and glow a solid blue when a connection is established between the soundbar and the wireless receiver. Your speakers are now connected! ^Gina
Sorry, there was a problem. Please try again later.