“I can not get my Samsung M360 soundbar to pair with my SWA 8500S wireless rear speakers.”
Answer This Question
1-2 of 2 Answers
Hi there! We're sorry to see that you are having difficulties with pairing your rear speakers. So that we can better troubleshoot towards a solution, please reach out to Samsung Support at: ― Phone: 1-800-SAMSUNG / Available 8 AM - 9 PM EST, Mon - Fri ― LiveChat or Email: https://www.samsung.com/us/support/#contact_us_for_support We look forward to hearing from you. ^Gina
Sorry, there was a problem. Please try again later.Connect the speakers' wires to the wireless receiver. To do this, insert the gray plug into the gray jack on the wireless receiver. Then, insert the blue plug into the blue jack on the wireless receiver. Attach the cables to their corresponding speaker. Match the gray cable to the speaker with the gray label on its back, and match the blue cable to the speaker with the blue label. Insert the red and black ends of each speaker wire into the corresponding red and black terminals of the appropriate speakers. Plug one end of the wireless receiver's power cord into a power outlet, and then connect the other end to the wireless receiver. The LINK LED indicator (blue LED) on the wireless receiver will blink. Some soundbars may need a wireless dongle attached to them to communicate with the wireless receiver and the speakers. If your soundbar requires this, please see your user manual for instructions. Turn off the soundbar using its remote or by pressing the Power button on the soundbar itself. Press either the VOL button or the Up button on your soundbar's remote. Hold down the button for 5-6 seconds until the “ID SET” message appears on your soundbar’s display. Note: Which button you need to press varies by model. Please read your soundbar's user manual for specific instructions. Turn the soundbar back on using its remote or by pressing the Power button on the soundbar itself. Some soundbar models will automatically power on after completing the "ID SET" steps. The LINK LED indicator will stop blinking and glow a solid blue when a connection is established between the soundbar and the wireless receiver. Your speakers are now connected!
Sorry, there was a problem. Please try again later.