1-1 of 1 Answer
First of all don't be fooled by the photo, this kit only includes one pair of metal brackets, not two. Even the Samsung website has the incorrect photo. It is designed for the 30 inch wide models only, which are the "9100 Series". The correct kit for your washer is SKK-7A. It has the correct metal brackets. That is the difference between these two kits. However you could theoretically make this kit work for your washer. There are two different ways. I am assuming that the washer and dryer are both 27" wide. One is to make your own bracket from a flat piece of metal. It should be at least 12 gauge and be about an inch above and below the dryer and washer mounting holes respectively. I would also use a little shoe goo between the plastic bracket and the washer to make sure the dryer doesn't walk. The nice thing about doing it this way is that the dryer will be exactly above the washer and thus require less depth to install it. (When you use the Samsung brackets, the dryer sits behind the washer a few inches and more depth is required to install them.) A second cheaper method is to simply drill new holes in the washer to accommodate the incorrect brackets. Of course you would have to do it yourself as no installer will do this for you. You also run the risk of damaging your machine by drilling or screwing into an internal part of the washing machine thus voiding the warranty and getting stuck with the repair bill. I highly recommend downloading both the washer AND dryer manuals and checking out the clearances required for installing these machines in a stacked arrangement. There are discrepancies between the two, and the dryer manual is more accurate These Samsung machines are taller and deeper than other brands.
Sorry, there was a problem. Please try again later.