“How do you hook it up via the screws it comes with? Does this require a drill? Not everyone has a drill and everything I'm looking at requires one.”
Answer This Question
1-1 of 1 Answer
Eejay, A drill may be used depending on the surface you are mounting the camera to. See the following mounting instructions.Remove the mounting bracket from the camera. Slide down to remove the mounting bracket from the camera. Mark and drill the appropriate holes in the wall for the mounting bracket. Place the mounting template against the wall where you would like to mount your Sight 180 Outdoor, using the level as a guide. Mark the wall with the four corresponding holes for screws. Remove the paper, and drill four holes slightly smaller than the wall anchors. Slide down, attach camera to the mounting bracket and fasten the screws. Slide the camera onto the mounting bracket, the mounting bracket allows you to tilt the camera up to 8° from its original position. Tilt the Sight 180 Outdoor until you have the ideal viewing angle and then fasten the screws on the left and right side of the camera. Fasten the screws through the holes on the mounting bracket.. Tap the wall anchors with a hammer until the anchors are flush against the wall. Fasten the screws through the holes on the bracket and into the anchors.
Sorry, there was a problem. Please try again later.