mophie - Snap Adapters for MagSafe Compatibility (2-Pack) - Black

I was pretty sceptical of these at first but I'm actually impressed. I have them on an OtterBox case for a galaxy s22 ultra. They're sticking to the case very well. No complaints there. If you try and stick it to a piece of metal like a fridge or something the magnets will somewhat hold tomit but it will slide down because of the weight. If you put the rings to an actual magsafe magnet say a car mount they lock on very well. They do work through my thick case for wireless charging. My only complaint is the instructions and and the little piece of cardboard they give you to align it on your case or phone. If you try and center the lines the ring went right through the camera slot on my case so I had to offset it so it just cleared and it seems to be just fine. The instructions are crap. It just says line up the lines. These are a great way to turn an android phone into magsafe.

Have a Phone case without magsafe? Wish you could use it While still using Magsafe charging? Well, now you can! Attach this to the outside back of the case and you are good to go. The prefect way to bridge the gap. NOTE ( This may not work with all cases) like really really thick cases. Best way to test. Connect the ring to the magsafe Charger, then press the ring against the case to see if it will make contact with your phone thru the case and charge. I use a Skinit, Inner rubber with Hard outer shell case. The best they offer. I have had this case for 7+ years. Only needed to change this ring starting yr 6. The best add on, a pop socket that Snaps on the ring when not on the charger. Super Slim as well. I deff recommend this. Apple should have included this with every iphone.

Works great! Have it in a case for my Samsung S20 FE and it works perfectly in a Magsafe charger. Only downside is it has a bit of a sharp feeling edge as it sticks up a little, but hasn't cut me.

While not as strong as Id like it to be, the magnet was able to hold the weight of my phone upright on a fridge. Since this is merely an adhesive magnet for your phone, it got a little annoying to constantly have the raised ring catch on my pocket. I decided to modify my phone case to allow me inset the magnet for a better fit. The included alignment and application guide was helpful in getting my placement of the sticker right. Im able to use magsafe phone holders, case attachments, and the like on my cheap Nord N20 5g phone case, which brings me a step closer to matching Apple's overpriced features with a budget phone.

This may have potential for older phones with no MagSafe, but personally it's not meant for myself. I do have an iPhone 12 which has MagSafe, but with a few NON-MagSafe cases, applying the ring on the back of the actual phone (Did not apply the adhesive to my actual phone) and then placing the non-MagSafe case over it did not work at all for me. And this most likely due to the thickness of the case. I then tried this time actually using the 3M adhesive on the smooth back of the thin plastic-like Non Mag-Safe case, but the stronger magnet of the Apple MagSafe charger only ripped the ring "Snap Adapter off" the case after 3 removals, leaving it attached to the actual charger. I did not try the other ring on my other leather case. *In Morphie's defense, there are no photos of the rings attached to a case, only the actual phone in promotion photos, and the box itself, also using that phone "naked." This could work for some. The magnetic ring could also possibly attach better to certain back of cases, the texture may make a difference. I cannot confirm that right now. It IS a thin ring so that is nice, I noticed this briefly and it won't get in the way when holding the phone. It also does not interfere that much with a case over it. If the magents were a bit stronger, this could work better. The box comes with 2 rings and a size chart to help you align the rings to your phone.