what is required for the wall mount null

Not sure on question. If asking about the unit itself, all you need is two screws to fit in the holes on the back of unit. If asking about hanging the receiver on the unit, you need to go to base and remove numbers sheet and you will find a clip on top and set it to use for hanging. (it will have a piece sticking up). Hope this helps.

I don't think it's good for the wall mount due to its bulk size than expected.

“what is required for the wall mount”

Asked by Anonymous 4 years ago

Answer This Question

See all questions & answers

AT&T - 210M Trimline Corded Telephone - White-Angle_Standard

1-3 of 3 Answers

Not sure on question. If asking about the unit itself, all you need is two screws to fit in the holes on the back of unit. If asking about hanging the receiver on the unit, you need to go to base and remove numbers sheet and you will find a clip on top and set it to use for hanging. (it will have a piece sticking up). Hope this helps.
Answered by Magoo 3 years ago
Sorry, there was a problem. Please try again later.
I don't think it's good for the wall mount due to its bulk size than expected.
Answered by EdwinatUSA 3 years ago
Sorry, there was a problem. Please try again later.
Regular wall mount phone jack
Answered by Yankee 3 years ago
Sorry, there was a problem. Please try again later.