“how to install? How do you install this book cover? The tablets has 2 button looking holes in back.”
Answer This Question
1-10 of 11 Answers
As they say, a picture is worth a thousand words\ Copy and Paste on the link below to see how to attach the case. It is really very simple https://www.youtube.com/watch?v=LSH17CM6X70
Sorry, there was a problem. Please try again later.If you notice the back of the tablet has the two holes that can be pushed in (by hand). The buttons on the cover fit into these holes and need to snap in to work properly. When you align the buttons with the holes press hard and you will hear them snap in. Be careful not to break the tablet glass if you have the tablet face up. Don't worry the Samsung rep in the store had a hard time figuring this out too. The flap that goes over the top of the tablet when closed actually bends back toward the bottom of the tablet when open (exposing the camera). It folds down about half way on the back.
Sorry, there was a problem. Please try again later.It just pops onto the tablet because the case has two little posts that snap into the tablet easily. I'm careful with stuff this case offers almost zero protection for falls or drops just so you know
Sorry, there was a problem. Please try again later.Simply press harder than you think you should on the buttons on the civer so they go into the holes on the back. Its hard to get it lined up so do 1 button at a time and dont worry about the 2nds placement. Once you get the first on in the 2nd one is easier.
Sorry, there was a problem. Please try again later.It just snaps right in.
Sorry, there was a problem. Please try again later.Just pop it into those two buttons. It's really simple and works well.
Sorry, there was a problem. Please try again later.the cover snaps right in the two holes on the back of the tablet
Sorry, there was a problem. Please try again later.There are 2 black rings on the cover that match up with the spring loaded holes on the tablet. You just line them up and snap them into the tablet. May have to push a bit, but snaps in snugly. Also stays attached.
Sorry, there was a problem. Please try again later.Just line up the snaps with the circle indentions on the BACK OF THE TABLET AND PUSH.
Sorry, there was a problem. Please try again later.You have to line the two buttons on the tablet with the two on the cover and push down hard. They have to snap in. I was hesitant to apply pressure but you must. Just be sure you do it directly in the area of the two buttons and on a flat surface.
Sorry, there was a problem. Please try again later.