“How would you know if this pack or ram would work in your motherboard? I have 4 slots will it work?”
Answer This Question
1-5 of 5 Answers
Check in the motherboard Bios/UEFI or the manual. Make sure your MB can make use of this memory's full speed and capacity. If you don't know how to access your MB Bios then look for a tutorial on youtube.
Sorry, there was a problem. Please try again later.Hi Drew, You'd check your motherboard's manual for confirmation. If you have any other questions, please reach out: support.corsair.com
Sorry, there was a problem. Please try again later.Typically the four slots are configured as two banks of two slots each (a low address memory set and a high address memory set), before removing the original memory from the system note where it is installed (usually the low set), that's where you want to install then new memory. If the existing memory is known good you might consider moving it to the remaining empty slots (the high set).
Sorry, there was a problem. Please try again later.Check your MOBO specs. It should work on most all DDR4 MOBOS
Sorry, there was a problem. Please try again later.Yes it will work just make sure you put them in the slots from left to right #1 and #3 slots so they are on the same link
Sorry, there was a problem. Please try again later.