“4 Ohm Speakers I have a set of Martin Logan Motion series surround speakers, so all 4 ohm. Will the receiver work with that impedance?”

1-2 of 2 Answers

• Yes it will, but you must change the settings as follows Carry out the following settings when using a speaker with an impedance of 4 – 6 Ω/ohms. 1. Press and hold the main unit’s ZONE2 SOURCE and STATUS at the same time for at least 3 seconds. “V.Format:< NTSC>” appears on the display. 2. Press DIMMER on the main unit twice. “Sp.Imp.:<8ohms>” appears on the display. 3. Press TUNER PRESET CH + or TUNER PRESET CH － on the main unit to select the impedance. 6ohms: Select when the impedance for any of the connected speakers is 6 Ω/ohms. 4ohms: Select when the impedance for any of the connected speakers is 4 Ω/ohms. 4. Press the main unit’s STATUS to complete the setting.

  Answered by Stryprod 10 years ago

  Helpful (2)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• Yes, it will work.

  Answered by PauleyAK 10 years ago

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.