“how do you connect the Dynex bannana plug to speaker wires?”

1-4 of 4 Answers

• Once you slide off the rubber end, there are two screws that must be loosened before the wire can be inserted. Once inserted, tighten the screws and slip the rubber end back on. Ready to go!

  Answered by osugrad92 12 years ago

  Helpful (4)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• There is a small (flathead) screw under the silicone sleeve that you loosen. The wire goes into the bottom of the clip, you tighten the little screw, and slide the silicone cover back over. Just make sure you have a flathead screwdriver small enough (like one you would use to tighten sunglasses or reading glasses).

  Answered by AJMac79 12 years ago

  Helpful (3)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• Just two set screws.

  Answered by Rockmetwice 12 years ago

  Helpful (1)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• Simply put these over the speaker wire ends and twist until they are secure.

  Answered by DynexCustomerSupport 12 years ago

  Helpful (0)Unhelpful (3)

  Report

  Sorry, there was a problem. Please try again later.