Questions & Answers

Q: QuestionWhat type of duct shape does it require for installation?

• A:Answer The product recommends using round ductwork instead of rectangular ductwork, especially if elbows are needed. If rectangular ductwork is used, it should be transitioned to a minimum of 6" (152 mm) round for internal blowers and 10" (254 mm) round for remote blowers as soon as possible.

Q: QuestionWhat is the maximum airflow capacity of this downdraft system?

• A:Answer The maximum airflow capacity of the Fisher & Paykel 30" Telescopic Downdraft System is 1200 cfm (cubic feet per minute). This information can be found in the product description: "Its variable speed controls operate at speeds of up to 1200 cfm."

Q: QuestionWhat is the weight of the downdraft system?

• A:Answer The weight of the 30" Telescopic Downdraft System by Fisher & Paykel is 21 pounds.

Q: QuestionHow does the telescopic downdraft hood retract when not in use?

• A:Answer The telescopic downdraft hood smoothly retracts for a discreet appearance when not in use, maximizing the 14" lift for optimal extraction.

Q: QuestionDoes it have a display to indicate the fan speed or other settings?

• A:Answer The product has a control panel with a single on/off button and a slider for precise fan speed control. However, it does not have a digital display to indicate the exact fan speed or other settings. NO_DISPLAY

Q: QuestionHow long is the included duct?

• A:Answer The included duct is 40 inches long. The product specifications section mentions "Duct Length: 40 inches".

Q: QuestionWhat is the color finish of this downdraft system?

• A:Answer The color finish of the 30" Telescopic Downdraft System by Fisher & Paykel is stainless steel. The product specifications clearly state: "Color: Stainless Steel".

Q: QuestionHow many fan speed settings does it have?

• A:Answer The Fisher & Paykel 30" Telescopic Downdraft System has a variable-speed fan. The fan speed can be easily adjusted to accommodate current exhaust needs by sliding the control slider on the right-hand side of the downdraft unit.

Q: QuestionWhat material are the grease filters made of?

• A:Answer The grease filters of the Fisher & Paykel 30" Telescopic Downdraft System are made of aluminum. For best maintenance, the aluminum grease filters should be cleaned with hot soapy water or in a dishwasher at least once a month, depending on usage. If washed in a dishwasher, the filter should be placed in an upright position to prevent food from falling on it.

Q: QuestionWhat is the required voltage for operating this downdraft system?

• A:Answer The required voltage for operating this downdraft system is 120 volts. The electrical supply should be a 120 volt, 60 Hz AC-only electrical supply on a dedicated 15 amp fused circuit. A time-delay fuse or circuit breaker is recommended.

Q: QuestionCan this downdraft system be used with a 6-inch round ductwork?

• A:Answer Yes, this downdraft system can be used with a 6-inch round ductwork. The product is "Designed to fit 6" round ductworks: For ease of installation."

Q: QuestionWhat type of control interface does it have (e.g., buttons, knobs, touch controls)?

• A:Answer The Fisher & Paykel 30" Telescopic Downdraft System features a simple control interface with a single on/off button and a slider for precise fan speed adjustment. The power button is located on the top trim, while the blower speed slider is situated on the right-hand side of the downdraft unit.

Q: Questioncan this unit be place behind a range and vent sideways?

Asked 1 year ago by Luke.