“My actual humidity% stopped showing on the display. If I switch it to CO, it just keeps reading CO instead of the actual %. I need to closely monitor my humidity since I had a mold problem. Turning off/on doesn't help. Is there a reset or is it broken?”
Answer This Question
1-4 of 4 Answers
Did you set it to a desired humidity threshold? "CO" means continuous operation... so it's not going to stop until- 1) you set to a desired humidity 2) the collection reservoir is full 3) you deprive it of power If you are that worried about mold forming so quickly, leave on a low humidity or CO.
Sorry, there was a problem. Please try again later.Put it on the number you want to maintain. Then it will read the you the actual % once it’s ran for a couple of minutes.
Sorry, there was a problem. Please try again later.CO means continuous running fan and displaces the readout. Also the readout is the setting and does not measure room humidity. Go to a hardware store and buy a cheap thermometer that also reads humidity.
Sorry, there was a problem. Please try again later.Hello, Frigidaire Friend. Thanks for reaching out. Bummed out to hear you are not able to see the humidity percent displayed on your dehumidifier. Have you tried using a different electrical outlet? Please keep in mind when using “CO”; this means the unit is running continuously. When the unit is first plugged in and turned on, it will run in this mode. It is best to maintain this mode for 3 - 4 days or until conditions have improved. Should the above suggestions prove ineffective, please give us a call directly at 888 203 1389. Our Customer Care Team is available Monday through Friday from 8am-8pm EST and Saturday from 9am-6pm EST. Regards-Derrick
Sorry, there was a problem. Please try again later.