“My Homedics Humidifier Model:UHE-WM70 ran completely out of water. I filled it up and now it won't start. The button light blinks on and off a few times and then goes out. Do I need to prime it. If so, how? If not, what do I need to do?”
Answer This Question
1-2 of 2 Answers
Just fixed mine. unplug the unit and empty the water. remove the center section and take the screw out of the water level sensor (white piece). turn unit upside down and tap to get both white parts to fall out. the donut shaped part is the float. clean out the area where the float belongs as the float was probably stuck in the "no water position". reassemble and fill the water. it should work.
Sorry, there was a problem. Please try again later.Remove the both tanks and adjust base white plastic part with screw to lock situation(you can feel when turn it round). if it loose tank wont fit properly to base power button will blink and stop
Sorry, there was a problem. Please try again later.