A:AnswerYou're going to probably want a fast blow definitely depending on the size and be the BB a 5 mm by 20 mm or a 5 mm by 10 or 5 mm by 30 mm size fuse but definitely a 5 amp or so fast blow 250 volt 5 amp 250 somewhere in the air maybe a 6 amp it will say on the receiver but definitely fast blow
A:AnswerYou got speaker wires touching each other or reversed polarity look on the back where you got them plugged into the ports of speaker wire and make sure there's no loose strands touching the other side it's going into protective mode either that or you got something set on top of it and it's not releasing the Heat and it's heating up the internal components hot enough to set off protection mode it's saving itself from you exploding it you're doing something or flipped around reverse the polarity on one of them backwards
A:AnswerNo it's not bridgeable the stereo receiver to I'm not even sure why you would want a bridge that I mean it's not a Power Inn 2 2 Channel basic stereo tuner Bluetooth
A:AnswerI believe you can make it work by using the A/B speaker selector an run your subs off the B .
I have my sub done like this and it works fine...
A:AnswerConnect one pair of speakers to the top row of speaker connections (A) and another pair to the bottom row of speaker connections. (B). Now you can use the remote to choose to have sound coming from the A pair, the B pair, or both.
A:AnswerJust a guess. Those speakers spec as too difficult a load for this receiver, but you could always give it a try. Make sure the speakers are at least 8 ohms impedance. There is no fudge factor in this!
