A:AnswerHello there,
Door slightly pull out the crisper pan. Then push up on the bottom of the glass. And then remove the glass shelf.
Insignia Support,
Merjorie
www.insigniaproducts.com/support
A:AnswerI believe the packaging was adequate providing the unless the fridges are being mishandled or subjected to excessive pressure from surrounding devices.
A:AnswerHi Jonnay,
Yes, we can have it shipped to you but the amount for the shipment is depending to the location and to the carrier itself. The estimated get it by date for this product to be shipped to would be on Mar 30 - Wed.
Insignia Products
Nikki
https://insigniaproducts.com
A:AnswerLet your refrigerator stand upright for approximately four hours before connecting it to power. This reduces the possibility of a malfunction in the cooling system from incorrect handling during transportation. For product support, please visit https://www.insigniaproducts.com/email-us
A:AnswerNo, this refrigerator cannot be installed under a cabinet/built-in. Allow 5 in. (12.7 cm) of space between the back and sides of your refrigerator and any surrounding walls. This allows the correct air ventilation.
A:AnswerYour refrigerator is not designed for a recessed installation (under a counter). Allow 5 in. (12.7 cm) of space between the back and sides of your refrigerator
and any surrounding walls.
A:AnswerHi there!
Mini fridges freeze because of temperature settings, moisture buildup, and in many cases, a bad gasket. If there's a bad seal, the air temperature will be off, forcing the compressor on, which will speed up the freezing process of all the moisture seeping into your mini fridge.
If you have any other concerns, you may use the link below to reach us.
Insignia Support
Dina
Please visit https://www.insigniaproducts.com/contact-us
A:Answermost refrigerators have a large opening in the back where the compressor/motor are housed. and while it creates a large area for air to enter and the heat to dissipate, it is also best to allow air to move under the fridge as well. I would suggest if you want to place it on a carpeted area, that you put down a piece of plywood or some other flat surface that doesn't need to extend around as the same size of the fridge, but will allow the feet to sit on to raise up off the carpet.
