“How do I change out the beer line? I can't even get a wrench into the draft arm to loosen the connector.”
Answer This Question
1-4 of 4 Answers
Professional way: special tool made to fit. My way: disconnect the line from the keg, run the line through the box end and up to connector. Use a vice grip and twist apart (ideally with a thin rubber membrane in between or you will strip the chrome finish.) Once the screw is off there is enough play to get to the line and disconnect it (even if there’s a clamp.)
Sorry, there was a problem. Please try again later.Did you ever figure out how to take the beer line out?
Sorry, there was a problem. Please try again later.I don't know how to reply to an answer, so I'm quoting it here and replying this way: "Your Kegerator came with a small metal wrench that is used to take the tap off to allow for cleaning the beer lines. Once removed, you can take the beer line off on tap end and pull through the tower and replace." So I used the wrench and the taps came off fine. But I don't know what to do after I take the spring out. I still don't know how to pull the line through, as there are still a bunch of metal parts blocking the way. How to I remove those?
Sorry, there was a problem. Please try again later.Your Kegerator came with a small metal wrench that is used to take the tap off to allow for cleaning the beer lines. Once removed, you can take the beer line off on tap end and pull through the tower and replace.
Sorry, there was a problem. Please try again later.
