“At almost the end it said to connect piece I and K with 16 screws.... at the top where we would connect I On the desk it only has 10 screw holes. What are we supposed to do as far as the rest? We would have to screw thru the wood to get the rest in?”
Answer This Question
1-4 of 4 Answers
I was concerned about this at first, also. It is not a real problem - the screws are almost like self drilling screws and the wood is soft so with just a little pressure you can push down on the screw and begin screwing the back down to the frame. If you use the smaller piece as a guide - by using the pre-drilled holes to attach this piece to the frame once you have done that you can line up the larger piece with the smaller piece and carefully begin to screw the screws in to the frame. You can space them out around the frame so that it is secure ( I still had more holes than screws but it was enough to secure the back and that's the key it's still just the back and not going to be seen. I did it without a power screwdriver so it's not hard just time consuming!)
Sorry, there was a problem. Please try again later.You will have to drill holes for the screws. I used a 3/32 bit.
Sorry, there was a problem. Please try again later.Yes, you need to screw thru the wood holes on back panel.
Sorry, there was a problem. Please try again later.we had the same problem/ we just put the extra screws in our junk drawer. the people that made this didn't put enough pilot holes in. Duh ?
Sorry, there was a problem. Please try again later.