“The last linksys extender i had was a 3000 they told me at best buy just to plug into the wall outlet and that it went indicator light turn green it good to go is that right”
Answer This Question
1-5 of 5 Answers
Basically that is correct. It finds the network and syncs as long as you initially plug in next to existing router and press sync button on your home router to have it send signal. Once it goes green and you do twice for both bands 2g and 5g you can unplug and relocate and it will go green if it is close enough to the origianal router to get a signal. It will go orange if not. If not simply plug into an outlet closer to the original router until you find the best location for you and it goes green. That is it.
Sorry, there was a problem. Please try again later.That’s how the older 1900AC worked for me.
Sorry, there was a problem. Please try again later.No, there is a little bit of set-up but very easy directions. It works with 2.4 and 5.
Sorry, there was a problem. Please try again later.No. You will need to connect to it and follow the setup wizard. It is simple and gives you clear steps to follow but it will not just work out of the box.
Sorry, there was a problem. Please try again later.Hi, goose. Check out this link to know more about the Linksys RE3000W's LED Behavior: https://www.linksys.com/us/support-article?articleNum=143635. Should you need our assistance with your device, feel free to e-mail us at [email protected].
Sorry, there was a problem. Please try again later.