“How to set up IPv6 on AT&T service? I get the IPv4 connection fine when I run auto set up.. Cant get the Ipv6 unless I use router as a acess point. Tried all settings in the advance menu for IPv6, still no sucess. Thanks”

1-3 of 3 Answers

• Why not using your att in bridge mode?

  Answered by Daniel 7 years ago

  • Verified Purchase
  • 

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• this router is fully automatic between 4 or 6 on that ipv

  Answered by sph1 7 years ago

  • Verified Purchase
  • 

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.

• You need to put the ATT gateway into pass thru mode in order to activate the IPv6 on the Netgear router. There are some good blogs on how to put your gateway into pass thru mode.

  Answered by BGauthier 7 years ago

  • Verified Purchase
  • 

  Helpful (0)Unhelpful (0)

  Report

  Sorry, there was a problem. Please try again later.