How do I replace the old blaze with new ones? null

Pop the razor head cover off the razor. Thereplacement blade box has a tool(orange in my box) that fits over the flange on each razor head, attach,squeeze and rotate about 1/4 turn counterclockwise and lift out each blade. Clean the razor cover, then replace each blade in the reverse of above directions. Pay attention, the blade head only fits a certain way and will not seat or lock in unless correctly inserted. Hope this helps

just open as if to clean & take the orange tool that came with the new blades & twist the orange caps to open & take out old & put in new than replace. this is for the ARCITEC

Pull the head assembly off as if you are going to manually wash it. Turn it over and each head will be held in place by an orange ring. Use the tool that came with them to turn it counter clockwise about an 1/4 turn to release the old head. Place the new one in the same location. Put the orange ring over it. Align the slots in the ring with the holders in the head unit. Push down and turn counter clockwise about a 1/4 turn. I recommend doing one at a time so you can compare the new with the old.

Use the Orange Toll that was included. It will fit on the heads (from the INSIDE of the razor head). Squeeze it together to grasp each head, with slight downward pressure, and turn it counter-clockwise. You will hear a click, and the old head can then be removed. Use the same method, turning clock-wise, to install the new head.

“How do I replace the old blaze with new ones?”

Asked by Anonymous 6 years ago

Answer This Question

See all questions & answers

Philips Norelco - SH90/52 Replacement Shaving Heads - Silver-Angle_Standard

1-4 of 4 Answers

Pop the razor head cover off the razor. Thereplacement blade box has a tool(orange in my box) that fits over the flange on each razor head, attach,squeeze and rotate about 1/4 turn counterclockwise and lift out each blade. Clean the razor cover, then replace each blade in the reverse of above directions. Pay attention, the blade head only fits a certain way and will not seat or lock in unless correctly inserted. Hope this helps
Answered by MikesApple 6 years ago
Sorry, there was a problem. Please try again later.
just open as if to clean & take the orange tool that came with the new blades & twist the orange caps to open & take out old & put in new than replace. this is for the ARCITEC
Answered by Anonymous 6 years ago
Sorry, there was a problem. Please try again later.
Pull the head assembly off as if you are going to manually wash it. Turn it over and each head will be held in place by an orange ring. Use the tool that came with them to turn it counter clockwise about an 1/4 turn to release the old head. Place the new one in the same location. Put the orange ring over it. Align the slots in the ring with the holders in the head unit. Push down and turn counter clockwise about a 1/4 turn. I recommend doing one at a time so you can compare the new with the old.
Answered by Dave 6 years ago
Sorry, there was a problem. Please try again later.
Use the Orange Toll that was included. It will fit on the heads (from the INSIDE of the razor head). Squeeze it together to grasp each head, with slight downward pressure, and turn it counter-clockwise. You will hear a click, and the old head can then be removed. Use the same method, turning clock-wise, to install the new head.
Answered by Kent 6 years ago
Sorry, there was a problem. Please try again later.