1-3 of 3 Answers
The "red" wire goes to your reverse lights. Once spliced into your back up and or reverse lights this system acts as activation for your reverse camera.
Sorry, there was a problem. Please try again later.In order to connect the red wire, I had to remove the tail light assembly at the rear of my truck, it was only a couple of screws to remove the tail light. Remember, it is the whole tail light housing assembly. There you will find the correct wire, the instructions will explain which wire to connect the red wire. I connected it to the left tail light, I don’t think it matters what side you connect the wire to. I hope this helps.
Sorry, there was a problem. Please try again later.Connect the red wire for your Honda CR-V with the reverse light wire. Find the wires that lead into the bulb one of them is hot/power you need to tap into this. Easy way make a opening in both wires and test then one at a time by putting the red wire to one and putting car in reverse if you see the STOP and grid lines pop up you have found the right wire. If not do the other one and you will be golden. It’s a 50/50 shot you get it right the first time. If you have a Multimeter you can take out the guess work if you don’t use the technique I stated.
Sorry, there was a problem. Please try again later.
