DS18 Audio - PSW 10" Shallow-Mount Subwoofer, 500W RMS Dual 2-Ohm
Reviews coming soon
About this product
The PSW10.2D is a 10" car subwoofer from the DS18 PSW series. It handles 500 watts RMS and uses dual voice coils at 2 ohms per coil, so you can wire multiple subwoofers to the final impedance your amplifier is stable at. Peak power handling is 1000 watts. The water-resistant cone holds up to moisture and spray in open-air installs. The shallow-mount basket fits tight spaces and under-seat enclosures where a standard-depth subwoofer will not clear. Mounting requires a 9.2" cutout diameter and 3.0" of mounting depth, so confirm your enclosure before installing. Pair it with a matching monoblock amplifier and a properly tuned enclosure to get the most low-frequency output.
Woofer Size
10"Features
500W RMS / 1000W Peak Power Handling
Rated at 500 watts RMS and 1000 watts peak. Behind that rating: 2.5" voice coil on an aluminum former wound with Copper wire and a 58 oz ferrite motor. That is what lets a 10" cone move this much air without losing control.
Dual 2-Ohm Voice Coil
Dual voice coils let you wire multiple subwoofers in series or parallel to reach the final impedance your amplifier is stable at, which gives you room to grow the system later.
Shallow-Mount Design for Tight Spaces
The shallow mount basket fits under seats, behind seats and in tight factory locations where a standard depth 10" subwoofer will not clear. Confirm your available mounting depth before ordering.
Fitment and Recommended Enclosure
This 10" subwoofer requires a 9.2" cutout diameter and 3.0" of mounting depth. DS18 recommends a sealed enclosure of 0.5 cu ft. Check these numbers against your enclosure before ordering: enclosure volume and tuning change the low-frequency response as much as the driver does.
84dB Sensitivity
A 84dB sensitivity rating turns amplifier watts into audible output efficiently, so you get more usable bass from the power you already have.
Specifications
- RMS Power500 wattsPeak Power Handling1000 wattsImpedance2 ohmsSensitivity84 decibelsDual Voice CoilsYesWoofer Size10"
Reviews
This product doesn't have any reviews yet.
Compare similar products
The PSW10.2D is a 10" car subwoofer from the DS18 PSW series. It handles 500 watts RMS and uses dual voice coils at 2 ohms per coil, so you can wire multiple subwoofers to the final impedance your amplifier is stable at. Peak power handling is 1000 watts. The water-resistant cone holds up to moisture and spray in open-air installs. The shallow-mount basket fits tight spaces and under-seat enclosures where a standard-depth subwoofer will not clear. Mounting requires a 9.2" cutout diameter and 3.0" of mounting depth, so confirm your enclosure before installing. Pair it with a matching monoblock amplifier and a properly tuned enclosure to get the most low-frequency output.
Experience pounding bass with this CompRT 10-inch subwoofer. This slim speaker is fewer than 4 inches deep for easier mounting. It features dual 2-ohm voice coils and employs a large-diameter, progressive-roll spider for minimal distortion. Use this CompRT 10-inch subwoofer with a sealed or ported enclosure and 400W of power.
Experience rich, precise bass from a low-profile installation with the NVX SQW104 SQ-Series 10" slim car subwoofer. Polypropylene cone, rubber surround, custom-tooled die-cast aluminum basket, and 16 mm Xmax help preserve depth, control, and tonal accuracy. With 600W RMS power handling and dual 4-ohm voice coils, this NVX subwoofer brings high-end sound quality to stealth truck and cargo-saving enclosures.
If your vehicle’s audio system is not giving you the sound you want, the TS- D10LS2 10" shallow-mount subwoofer might be what you are looking for. It was built to handle up to 350 W RMS with the ability to deliver impressive low frequencies. This subwoofer features an injection-molded polypropylene IMPP™ cone infused with Aramid fibers for exceptional precision and strength. The butyl rubber surround supports the subwoofer during cone excursion resulting in low distortion of the bass notes even when the music is turned up loud. With a mounting depth of only 3-5/16”, this subwoofer will fit in spaces regular subwoofers will not.This subwoofer has a 2Ω impedance useful for getting most out of a mono amp or for building multi-subwoofer installations.
| Pros for DS18 Audio - PSW 10" Shallow-Mount Subwoofer, 500W RMS Dual 2-Ohm | |||
|---|---|---|---|
| There were no pros for this product— | Sound Quality, Bass, Power, Price, Size | There were no pros for this product— | There were no pros for this product— |
Specs
Be the first to ask a question.
We’ll try to get your question answered within 24 hours by a Best Buy customer or brand representative.
Customers often buy these together
Kenwood - KAC-531 Class D Digital Mono Amplifier with Variable Low-Pass Crossover and Bass Knob - Silver
$199.99The price was $219.99
More to consider
$249.99The price was $269.95
Enjoy your ride Sponsored
$89.99The price was $99.99
Keep exploring
- $249.99The price was $269.95
$471.95The price was $589.95
$145.25The price was $153.67
$143.35The price was $144.51
