“How do you bend these? I see on the instructions that they can bend up to 90 degrees but that seems quite impossible at the moment. Is there a trick to it? Thanks”
Answer This Question
1-2 of 2 Answers
Completely impossible without cutting and using connectors. I pinched the corners to make it go 90 degrees.
Sorry, there was a problem. Please try again later.In order for you to bend the light strip at a 90 degree you need about 12 inches of the light strip. You don't want to bend it at a sharp corner, but at a gentle curve to the desired 90º. To successfully bend the LS we used a circle of an 8" circle. Make sure the connector (if using the extension) is not at bend. Also, clean and prep the area that the LS will be adhered to as outlined in the information booklet that came with your LS.
Sorry, there was a problem. Please try again later.