A:AnswerIf you go from under the sink and grab the right fittings from a hardware store, I don’t see why not. You could probably put a tee fitting on the hose under the sink and put a valve on it. Then you could connect/disconnect the garden or washer dryer hose to the appliance at your leisure.
A:AnswerHello- Thank you for your question and your interest in the new Ultrafast Combo unit! This amazing unit has an industry first UltraFresh System with Microban® Antimicrobial Technology to help prevent odors and ensure the Combo stays fresh and clean load after load. Eliminating having to worry about mold or bad odors. However, if you run a wash only cycle, we recommend leaving the door propped open to help dry out the interior. Of course, wiping down the gasket is recommended from time to time. If you run a wash and dry cycle, you won't have to leave the door open because the drying portion of the cycle will help to dry out the interior. If you have any additional questions or need anything else feel free to reach out and let us know. Dianna@GEA
A:AnswerHey there,
Thanks so much for asking your question. We'll be happy to answer. The Combo does not spray water on the condenser or evaporator. You can manually clean out the evaporator that is accessible through the lint filter opening while taking care to not damage or bend the fins of evaporator. No condenser cleaning is required. Let us know if you have any other questions. Mike@GEA
A:AnswerHi there - those are great questions! The case depth (rear to the inseam) without the curved front is 26". For example, if installing this with side cabinets, this would be the "body" that's in the cabinet. -- The minimum clearances are 0” for the rear, sides, top, and front. However, to enable 0” clearance on the back of the Combo, you must use 90° elbow hoses. Otherwise, you may require some additional clearance to avoid rubbing of the hoses against the back wall. For more information, see the Installation Instructions on page 22 of the Use and Care Manual. We hope this is helpful and reach out anytime with additional questions. Have a great day! Lauren@GEA
A:AnswerHello - For the best drying performance, it should be installed in an area that has an ambient temperature above 60 degrees F. In other words, items will dry faster if temperatures are not too cold. Unit should not be stored or operated in temperatures below 32 degrees F or above 110 degrees F. We recommend that you review pg. 22 and 23 of the owner's manual for the location requirements and clearances for the Combo. Please let us know if you have any questions in the future. Kind regards. -Don@GEA
A:AnswerHello. Our Combo can indeed use laundry pods rather than liquid detergent, if you prefer! Just make sure you add the pods to the basket itself before clothes are added, rather than putting them in the SmartDispense. We also recommend following manufacturer instructions regarding usage of the pods. We hope this helps! -Sarah@GEA
A:AnswerHi - Thank you for your interest in our new Profile washer/dryer combo unit. The door on this model is not reversible. This is a great model and we are excited for it to become available We are confident you will be delighted with the many features it does offer. All our best! Vikki@GEA
A:AnswerNo, our UltraFast Combo Washer/Dryer is only compatible with a 7" riser and should not be installed on a pedestal. Therefore, only the riser model number GFR0728 is approved for use with the Combo. Even though the riser shares the same installation instructions with the pedestal, we do not recommend any pedestal.
A:AnswerHello- We appreciate your interest and suggestions! The Ultrafast Combo can be used with only the cold water hose connected. This model does not have a heater to heat incoming water; the incoming water temperature is dependent on the water in your home. So if you only have the unit connected to a cold water source, you will only be able to get a cold water wash. We hope this helps and if you have any other questions feel free to reach out and let us know. All the best! Dianna@GEA
A:AnswerHey there. We’re thrilled you’ve purchased our Combo, and we’re confident it’s going to revolutionize your laundry experience! The Combo is compatible with washer floor tray PM7X2; the dimensions for that are: 29" x 33" interior (31" x 35" exterior) 1.64" deep. The tray may be available through your dealer, or you can contact our parts department about the tray at 1-877-959-8688. Regarding an anti-vibration pan, that shouldn’t be necessary. The unit features Dynamic Balancing Technology to provide an overall reduction in noise and vibration. As long as the unit is properly leveled, we wouldn’t expect any issue with excess vibration. We also have not tested the washer/dryer combo with an anti-vibration pad, and wouldn’t be able to suggest using one. We hope this information is helpful – enjoy your Combo! -Sarah@GEA
A:AnswerHi - Our incredible UltraFast Combo sound level while washing is comparable to any of our other frontload washers. It is important that the Combo is properly installed and leveled, and the shipping bolts are removed to ensure proper operation. While drying the unit is quieter than standard dryers since the drum is insulated and there is no external venting. We have not been made aware of any issues with a rattle sound when installed on the riser. We are confident you will love our UltraFast Combo as much as we do. Kind regards - Vikki@GEA
A:AnswerGood day,
Thanks so much for your question! Two Combos can be hooked up next to each other and run simultaneously and independent of each other.
They need to each have dedicated 120V outlets.
The drain hoses can share the same standpipe as long as its ID is greater than 1.5”.
The water hookups can be shared used two adapters as follows: With a short hose and a y adapter the HOT line can accommodate both hoses for HOT water to each unit; and, with a separate short hose and y adapter the COLD line can accommodate two hoses for COLD water to each unit. We hope this helps. Have a great day! Mike@GEA
A:AnswerFor dry only setting just push the dry button after turning on. By default when turning on it goes to the wash and dry setting. From there you can select a timed dry or automatic dry or other options.
A:AnswerHi - We are so appreciative of your interest in our fabulous Profile UltraFast Combo. We offer the PM14X10008 - 4 ft. Universal Stainless Steel Washer Hoses with 90 degree elbow. When installed on the valve, the hose will need approximately 2.25" of clearance from the valve face. We hope this is helpful. Kind regards - Vikki@GEAppliances
A:AnswerThis all depends on the size of load, the option you select and if the filter is cleared or not. For me - king size sheets / pillow cases = 2 hours under bulk option. King size comforter = 2 hours under bulk option. Quick loads are like 1 hour 15 minutes under quick cycle option. Normal size loads are 1 hour 30 mins under normal size option.
A:AnswerHello - Vinegar or vinegar-based cleansers should not be used in the Combo. Vinegar is acid based and can be caustic to certain materials used in the Combo unit. We do not recommend using vinegar in this unit. Kind regards. - Vikki@GEA
A:AnswerHi there. The time our Combo needs to complete the cycle and dry your clothes can vary, depending on the specific load, the options/cycles you select, etc. As long as your clothes are dry, there should be no issue with ending the cycle earlier than expected. We hope this is helpful – all the best! -Sarah@GEA
A:AnswerHi - Thank you for reaching out to us and for your interest in our feature-packed Profile All-in-One Washer/Dryer Combo unit. We have good news! Yes, we do offer an optional unicoupler hose connector part - WH41X27468 that will allow you to connect this unit to your sink. We are glad you checked with us and we hope you choose this great model for your home. All our best! Vikki@GEA
