Questions & Answers

Q: QuestionWill this fit an old HP P6523W with a four pin connection?

Asked 5 years ago by mike.

• A:Answer I believe the CPU power has the option to run 4 pin or 6.

  Answered 5 years ago by dirkVerified Purchase

  Helpful (0)Unhelpful (0)ReportAnswer this question

Q: QuestionDoes this power supply have a 8 pin gpu connector? i see the 6 pin but i see no lable so im assuming the other 8 pin could be for the cpu?

Asked 5 years ago by willie21.

• A:Answer Yes, 8 pin for GPU and 8 pin for Pentium CPU.

  Answered 5 years ago by DogDoc

  Helpful (0)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionCan I take my PC with Insignia 450W ATX12V 2.4/EPS12V 2.92 80 Plus Power Supply to Europe? Will this work in Europe at 230 V / 50 Hz ?

Asked 5 years ago by Zibi.

• A:Answer No, it does not have a voltage switch for PAL region's higher voltage. You will need a new power supply that supports European power input or an external power converter like with all electronics.

  Answered 5 years ago by AntiOtaku

  • 
  Helpful (0)Unhelpful (0)ReportAnswer this question

Q: QuestionWill this work on my Acer Aspire ATC-120-UC22 desktop pc?

Asked 5 years ago by louie.

Q: QuestionDoes this for sure have 8 pin graphics connectors?

Asked 5 years ago by UxoriousBurrito.

• A:Answer Yes. Has two 6+2 connectors that are both 12volt. Allowing up to two graphics cards or one graphics card with an 8+8 or 8+6 power connector pin requirement. Although If you using a GPU with 2 8pin connectors, I might suggest a higher wattage rated unit, depending on the parts in the rest of your system.

  Answered 5 years ago by Supertramp

  Helpful (0)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionAre there any minimum loading requirements?

Asked 5 years ago by OldGuy.

• A:Answer There are no minimum requirements.

  Answered 5 years ago by Zack

  Helpful (0)Unhelpful (0)ReportAnswer this question

Q: QuestionI have a hp pavillion desktop and I think the power source is bad can I purchase one from bestbuy or debit have to be one exactly for the computer it self

Asked 6 years ago by Anonymous.

• A:Answer No it doesn't have to be the exact power supply. But you need to make sure it will physically fit inside your HP Pavilion desktop computer since not all PSU's are created equal. Case in point, I chose this particular Insignia PSU because it's slimmer than most PSU's so it was able to fit inside a Dell Precision T1600 I was fixing up. Worst case scenario, you can always return this PSU back to Best Buy for an exchange or refund if it doesn't fit. Hope this helps!

  Answered 6 years ago by LeeroyJenkinsVerified Purchase

  Helpful (0)Unhelpful (0)ReportAnswer this questionShow more answers (3)

Q: Questionwhat's the measurements of the power supply

Asked 6 years ago by Goody.

• A:Answer About 8.5 cm by 14 cm by 19 cm, the exact same dimensions as every PC tower or mini-tower power supply I have seen in the last several years.

  Answered 6 years ago by Ayespy

  Helpful (1)Unhelpful (0)ReportAnswer this questionShow more answers (2)

Q: Questionwhy is there no instruction manual I need the help

Asked 6 years ago by hymnz.

• A:Answer If you're looking for an instruction manual, you should take it to a computer technician. Not trying to sound rude or condescending but you could potentially damage the PSU and the internal computer parts if you're not sure what you're doing.

  Answered 6 years ago by LeeroyJenkinsVerified Purchase

  Helpful (0)Unhelpful (0)ReportAnswer this questionShow more answers (3)

Q: QuestionWill this power supply work in an hp elitedesk 800 g1 desktop?

Asked 6 years ago by Hppavillion.

• A:Answer No. This isnt a sff power supply

  Answered 6 years ago by mjhrph

  Helpful (0)Unhelpful (0)ReportAnswer this questionShow more answers (2)

Q: QuestionWhat are some motherboards out in the market right now for pc building that can work with this power supply?

Asked 6 years ago by trix.

• A:Answer I am pretty sure it will work with all the new models from 2014 to todays day 2019, just make sure you get one power supply with enough power for the motherboard and a graphic card in case you will need one, With 600w to 700w should be enough.

  Answered 6 years ago by Odiseo

  Helpful (0)Unhelpful (0)ReportAnswer this questionShow more answers (2)

Q: QuestionHow many DC volts is it

Asked 6 years ago by Ipacheco90.

• A:Answer Depends on the rail. There are +12 VDC rails, +5 VDV rails, +3.3 VDC rails, and -5 VDC rails.

  Answered 6 years ago by BluDragynVerified Purchase

  Helpful (0)Unhelpful (0)ReportAnswer this questionShow more answers (3)

Q: QuestionWill this work on my HP pavillion 57p-p033w?

Asked 7 years ago by Lee.

• A:Answer I can't give you a definite answer but it should work fine. It has all of the right power outputs. The HP computers I've seen all use a standard size power supply like this one.

  Answered 6 years ago by ZooDogVerified Purchase

  Helpful (1)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionJust bought the 450-watt power supply.My case has vents on bottom.Should the psu fan point UP,or bottom(Lottsa holes for venting on bottom of my case).Seems bottom would be best as up blows the heat to the INSIDE of my case.

Asked 7 years ago by yachtlover.

• A:Answer You would want it pointed down to take in fresh cool air. And if it doesnt have a filter you can buy a magnetic screen

  Answered 7 years ago by e46LS3

  Helpful (0)Unhelpful (0)ReportAnswer this questionShow more answers (4)

Q: QuestionHow long is the CPU power cable. I need it to reach from the bottom of the case to the top of the motherboard... I need it to be about 18".

Asked 7 years ago by stressed.

• A:Answer It’s 60 centimeters

  Answered 6 years ago by BenyapaVerified Purchase

  Helpful (0)Unhelpful (0)ReportAnswer this questionShow more answers (2)

Q: QuestionDo I the cables come with it?

Asked 7 years ago by Cart.

• A:Answer Yes, there are several different plug ends: Atx power fans, drives, sata

  Answered 6 years ago by BenyapaVerified Purchase

  Helpful (0)Unhelpful (0)ReportAnswer this questionShow more answers (5)

Q: Questionhow long are the internal conenections? not the power cord(external) but the 20/24pin etc?

Asked 7 years ago by jbdj.

• A:Answer I didn't measure them, so if you're wanting exact lengths, I can't help. Sorry, but I'm not going to open my box back up to measure them. That being said, there is quite a bit of real estate inside my box (full size ATX, not micro or mini), and I had no problem reaching everything from the front to the back (the power supply is in the upper back corner). If you need exact measurements, go to the store and take it to the Geek Squad desk. If they can even figure out how to take it out of the box, measure all the cords while it is on their counter. PLEASE post your results back here so some other poor soul can benefit from your work.

  Answered 6 years ago by CreateANickname

  Helpful (0)Unhelpful (0)ReportAnswer this questionShow more answers (2)

Q: QuestionDoes the Insignia™ - 450W ATX12V 2.4/EPS12V 2.92 80 Plus Power Supply have a 4 pin atx cpu connector and a 8 pin atx system connector?

Asked 5 years ago by Anonymous.

• A:Answer Yes it has both

  Answered 5 years ago by LukeWVerified Purchase

  Helpful (0)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionCan I replace a HP Bestec ATX-250-12z with this Insignia?

Asked 6 years ago by WildBill.

• A:Answer The HP Bestec ATX-250-12z is a standard ATX power supply, as is the Insignia; it should work in place of the Bestec.

  Answered 6 years ago by jjf60

  Helpful (0)Unhelpful (0)ReportAnswer this questionShow more answers (2)