“how do i connect an ads sw2 subwoofer to Onkyo tx-8140? it has 4 wire leads. is the amp powerful enough to not burn out? do i need any special connectors?”
Answer This Question
1-4 of 4 Answers
The sub out doesn't work with the B speakers, so only connect to A side if you want SW to work. "... connect the SW Pre Out to the line input terminal on a SW with built-in amp".
Sorry, there was a problem. Please try again later.I think you will need a power amp. The Onkyo single output is called a subwoofer pre (as in pre-amp). Pre > Power > SW
Sorry, there was a problem. Please try again later.The output speaker leads from A side amp output would feed your input leads on the sub. Then output from the sub goes to your A side speakers. Or. Feed the subs with the B side speaker output leads and fire up both A and B channels. Assuming you only have one set of speakers. If two sets of speaker. Then the sub gets connected inline with one of the channels. No rca jack on the sub? This amp has a dedicated rca output to run the sub.
Sorry, there was a problem. Please try again later.thanx for getting back to me. which power amp do u recommend & how is it hooked up? can u send me a wiring diagram? i have hooked up a powered Terk antenna. Onkyo provides a single wire antenna, while the Terk is 2 conductor wires. i have wired all three together. do u suggest otherwise?
Sorry, there was a problem. Please try again later.