A:AnswerHey fred, we value your time and would like to look into the concerns with your appliance. Please reach out to us directly at 1-800-253-1301, via Facebook https://www.facebook.com/whirlpoolusa or Twitter @WhirlpoolCare. We’re looking forward to hearing from you
A:Answerjbohnnybgood, on page 7 of the Owner's Manual of model WML75011HZ will show instructions on how to change the light. Hopefully, this information is beneficial to you. Thank you for your inquiry regarding our Whirlpool appliances!
A:AnswerWell I would think about returning it, since it’s not working like it should. Mine seems to be working well and hope it stays that way. You can open it manually on the bottom right hand corner where the door opens. The installer showed me that when they put it in. Hope that helps
A:AnswerHI Dale, please reach out to us so we can look into this for you.US: 1-866-698-2538
Hour of Operation:
Monday-Friday: 8:00 AM to 8:00 PM EST
Please locate the appliance's model and serial number before calling.
A:AnswerHello bruce! We are terribly sorry to hear of your concern. We would recommend contacting Whirlpool® at 1-800-253-1301. We are available weekdays, between 8 am to 8 pm EST. They will be better able to assist you.
A:AnswerHello! We are terribly sorry to hear of your concern. We would recommend contacting Whirlpool® at 1-800-253-1301. We are available weekdays, between 8 am to 8 pm EST. They will be better able to assist you.
A:AnswerHello bruce! We are terribly sorry to hear of your concern. We would recommend contacting Whirlpool® at 1-800-253-1301. We are available weekdays, between 8 am to 8 pm EST. They will be better able to assist you.
A:AnswerHello bneal! There is a 15" Bump out kit that can be used. It is part number W11185746. Thank you for your inquiry on our Whirlpool appliances.
A:AnswerOne way to do this is to put the unit on a table and sit the mounting bracket on the top as though it was mounted and hanging in place and tape it down. Then you can mount the damper to the rear of the unit as though it was in place on the wall and take actual measurements for the venting position. The mounting bracket fits nice and tight to the top of the unit so your measurements should be good. If venting through the back, make sure there is no wall stud where the vent will exit through the wall. If there is then you'll have to vent into the filter and not to the outside.
