1-3 of 3 Answers
The GE website says the traditional surge protector that is used for electronics would cause the compressor to shut down and possibly not restart. The compressor is designed to restart by itself if a surge is detected without one. The type of surge protector that would be suitable for a major appliance is one that protects the motor(s). This type would have to be installed at or in conjunction with the meter at the entry point of 3-cycle power to the home. I am fortunate in that the power company I use offers a monthy rental cost of only $6.50 for that service.
Sorry, there was a problem. Please try again later.The only type of surge protector that you can even use with that device would be at your central switch board (power box) typically found outside the home. I personally have not seen a surge protector that you can buy that will specifically fit the unique 4 pronged special plug for a 220 volt outlet. Just because I haven't seen one doesn't mean they don't exist, so if you find one than it wouldn't harm it. Definitely NO EXTENSION cords whatsoever! This can be very dangerous. As far as the outdoor surge protector, they are quite expensive (any where from a couple thousand to 5-6 thousand dollars). If you live an area that is prone to lightning strikes or power surges, than it might be a good idea. However if you don't have that scenario then I wouldn't spend the money on one. The only surge protectors I use are for my TV and computer systems and you can get a decent one for 50-80 bucks. Hope this helps out. ☺☻
Sorry, there was a problem. Please try again later.Hello AMarv, best practice for installations will have (based on local codes) either a direct wire or an approved Power Supply Cord with each connecting directly to the house electrical system and either setup or checked by a qualified electrician. No GFI or extension cords should be used nor surge protection devices need to be used.
Sorry, there was a problem. Please try again later.
