Customer Ratings & Reviews

This product works great! Never had a kegerator before this purchase...it was easy to set up and figure out how to use it. Keeps beer cold and fresh. Highly recommend it!

Nice kegerator for two “sixth kegs”....easily gets to 33-34 degrees. One improvement would be Perlick Faucets - easy change down the road.....regulator is nice easy adjustment for perfect pour minimal foam. Give it a try, you’ll like it!

Easy to put together and easy to work. Needed some adjustments to get CO2 correct. Start lower than expected do not follow the guidelines from book. So far excellent for the price.

I'm purchased this kegerator to replace an older model which finally went kaput and one with which a new compressor alone would have run as much as this new unit. This new Kegerator was delivered in soundly (no damage) even though there were a few rips and holes in the exterior box. I was able to assemble the kegerator in about 45 minutes without running into any issues. I did notice that some of the screws in the bottom of the unit were really loose so I would suggest to everyone to not only assemble what you're supposed to but to check all other fasteners as well for proper assembly. In the unit I received, once assembled, I was able to fit 2 standard 1/4 skinny kegs. Putting in 1, 1/4 and 1, 1/6th keg even left enough room for a stack of 6-packs to keep cool at the same time. The unit is nice enough overall and a good value for the price paid ($419) which was the sale price. At the full price, I would not have purchased it. Quality wise, let's just say, it's not a commercial grade unit. My older unit was and I have stood on it many times to get something off an upper shelf. With this unit I wouldn't dare try. The top surface is plastic and has a good amount of give to it with even a slight amount of weight placed on it. The tower, fastening to this plastic top also has a bit of give and when pulling on a tap handle pulls the tower forward a bit as well. So... if buying this unit, I believe you'll be pleased with it as long as you understand that you're getting a residential quality unit and you'll need to be 'nice' (gentle) with it.

This is a great kegerator for the money. I got mine on sale for $400.00 and they delivered free. It is cold enough, and will be great for my home brew. the suggestion for the tower cooler are spot on, as this eliminated the heady first glass.

The kegerator arrived in a reasonable amount of time... or should I say that the wrong one arrived in a reasonable amount of time. Getting Best Buy to correct their error and get the right one shipped out was a rather challenging adventure involving numerous calls with long wait times and support staff that seemed like their priority was getting me off the phone and out of their hair. Ultimately, it seemed that a few FaceBook posts on the Best Buy site is what had the most impact in getting the issue straightened out. In the long run, the first (incorrect) kegerator arrived 1 week after ordering and the replacement (correct) one arrived 10 days after that. The final (correct) kegerator arrived with the box a little beat up with a few holes punched in it and upon unpacking I found the Styrofoam packing on the corners and the bottom to have been broken a bit but there was no apparent damage to the kegerator and, after all, that is the important part. Assembly took about 40 minutes and there were instructions (in english) enclosed which listed the parts and how they were to be assembled so the assembly went well and without any hitches. When installing the wheels, I did note that there were numerous other screws on the bottom the cooler that were very loose and required re-tightening and a couple were put in crooked to begin with which made them a bit harder to really tighten down so be sure when assembling, plan on checking all other screws you see even if not directly related to the assembly itself. The CO2 and the tap lines are all overly generous with respects to the length to whit I'll most likely be trimming them back once the unit is in full use so there's not an excessive amount of excess lines to mess with. While there is a bracket which can be attached to the back of the cooler to hold the CO2 canister I opted to use the small shelf in the interior to set the CO2 canister on, thus allowing me to get the cooler as close as possible to the wall and not stick out too far. Once assembled, even with the CO2 canister inside, I was able to fit two standard 1/4 barrel slim kegs inside and the door still closed easily and completely. Using at least one 1/6 barrel slim instead of one of the 1/4's then allows enough room to place an additional six-pack or 3 (if stacked) or a bottle or two of some other beverage. Overall, this seems like a nice enough unit. It's running quietly and keeping the beer nice and cold. My primary reason for scoring it 4 out of 5 stars is primarily due to the 'plastic-y quality' that it has. The drip tray and top grate are plastic as is the top of the cooler. Even after tightening the tower screws as much as I dare, you can still move the top of the tower back and forth about a half inch or so. You dare not even consider putting any sort of heavy weighted items on the top - especially near the front as you can easily press down on the front center of the top and see the plastic top sag under the weight. So, just keep in mind that this is a residential unit and not really meant for any sort of commercial or heavy use. The old unit I replaced was sturdy enough to where I had no second thoughts of jumping on top to reach the ceiling if I needed to but this unit I wouldn't even consider doing that with. I paid $419 for mine (supposedly on sale from $549). The $419 I would pay, but at $549 I would consider it to be overpriced for the quality of the unit.

I feel compelled to share my experience, especially after reading the Q&A section regarding use of 2 kegs in the cooler. The instruction book shows the following in regards to which kegs can fit inside. If you are unsure of what these look like, go to kegerator.com and look up keg sizes to see accurate pictures. 1. You can fit only (1) 1/2 Barrel Keg (typical size almost all bars and restaurants use for on tap beer) 2. You can fit (2) 1/6 Barrel Kegs 3. You can fit (1) 1/4 Barrel Slim and (1) 1/6 Barrel Keg 4. You can fit (1) 1/4 Barrel (Pony) which is short but wide ***5. You can fit (2) 1/4 Barrel Slim Kegs (Take note - the gasket does not make full contact and is roughly 1/4 inch from closing. I personally used duct tape in 3 areas (bottom,middle,top) and this is keeping the door completely closed and sealed). Obviously, I can't store mugs or glasses inside anymore because I'd rather keep (2) 1/4 Slim kegs than (1) 1/6 and (1) 1/4 keg and some mugs mainly because your beer selection opens more when you go up to the 1/4 size kegs. If the manufacturer used just a bit more material and made the depth maybe a 1/2 inch deeper, 2 would fit and the door would close no problem!! **** Besides this, the only thing I am having issues with are the faucets. If you go a few days without any pours, they seem to "seize" up and it takes a bit of strength to get them to "break" open to allow you to pour beer. For me, I have it set to level 5, but I also built a small air box inside to circulate the air. Once I put this custom box inside with USB Fans, it helped out a lot! I hope this helps someone, because between reading reviews and the Q&A, there didn't seem to be accurate details on this. Other than what I mentioned above, I must say that as if having beer at home, didn't make us lazy before, having a kegerator takes our laziness to a whole new level. The fact that I can just grab a mug and fill it up, makes me feel super lazy, but I love it! Hope this helps everyone reading!

Got this as a gift for my hubby for Father's Day. Keeps the beer nice and cold and love that we have 2 options to have on tap. Only minor complaint is it's a little noisy when running.

We are enjoying this kegerator very much. Easy set up. Takes a little adjusting to get the temp set right, and I will upgrade to a dual co2 regulator, but overall a great unit for the price!

Works fantastatic. Keeps the Beer nice and cold. Easy set up. Would have given 5 stars but one of the taps is off center just a bit. So if I add my own taps they would collide.

was looking for a dual tap kegerator at a good price, product arrived in a timely manor. One of the beer couplers was faulty and after numerous calls, and two hours on the phone with costumer services, I was connected to a supervisor who helped me remedy the situation. Works fine since I got the part I needed. I would recommend it to someone looking for a kegerator at a good price, does what I need it to do.

If you're looking for a good [price friendly] dual tap kegerator, this is it. Easy to put together....keeps the beer cold.

It really should have been made 2 inches taller so all basic kegs could fit easily. It also has an irregular shaped interior that really should be about 2 inches deeper to solve some minor problems. The cost of this would have been very little and it could have been a 5 star rating otherwise. It does keep very cold inside, runs very quietly and uses very little energy. The yellow energy tag says $37 annually (if that can be believed). All in all it is a pretty nice unit for the money if used only in a home environment.

We've been pretty pleased with our 2-tap Kegerator. My husband is a hard cider drinker and I like beer, so 2-taps allows us to both have our favorite beverages ready to dispense. We found it relatively easy to assemble the hardware. It comes with an optional set of casters for the bottom, so you can wheel it around. The hoses and taps all look to be of good quality. It's nice that they provide a away to mount the CO2 tank on the outside as well as the inside of the fridge. The temp setting is a bit fussy to set and you'll need to provide your own thermometer. But once you figure out where to set the dial, it stays pretty close to that temp. TIP:// Have it shipped to the store for pick-up. It gets palletized for shipping. If shipped to your door, it does not and will likely show up damaged. Our friends had theirs shipped to their house and both times, it arrived with major shipping damage.

Looks good, quality built, quiet and easy to assemble. Had to return first one due to shipping damage.

It's a great dual tap tower kegerator for the price when it was on sale at $430. Works properly, has a nice sized co2 tank, regulator is a little finicky though. When I have it on 3 cooling (goes up to 6) it has frozen one of my sixtels already. Wish the temp gauge was digital on the front like the other grey metal model as advertised, instead of having a thermometer now.

Was a good price only was missing a few things but the customer service is fixing that which is greatly appreciated. Seems to be working great, would recommend getting more hose line for the tap so beer has more time to settle when coming out of the tap.

Upgraded from a single tap Haier to this double tap model. Little disappointed the temp control is in the back and no digital display option as there is a space in the front for display. Overall I am pleased with my Father's Day gift. Cheers

We remodeled our basement and purchased the kegerator in order to have a variety of draft beer on hand. This is the perfect size. Fits nicely in our space and allows us to purchase two different flavors. So glad I bought it.

The kegerator cools efficiently. It is quite easy to set up. Recommend making or buying a tower cooler as well as installing longer lines. Overall a decent product that gets the job done.