1-4 of 4 Answers
In the User Manual (found in the Support/Downloads tab), of this page: http://www.dynexproducts.com/products/computer-accessories/DX-520WPS.html, it states that the wire configuration is as follows: 20+4 PIN Main Power Connector (1): Connect to motherboard 8 PIN (4+4)+12V Processor Connector (1): Connect to the motherboard for the CPU. 4 PIN Peripheral Connector (3): Connect to the internal IDE drives Serial ATA Connector (4): Connect to the internal SATA drives 8 PIN PCI-E Connector (1): Connect to the PCI-E graphic card that requires power. 6 PIN PCI-E Connector (1): Connect to a PCI-E graphic card that requires power Floppy Drive Connector (1): Connect to the 3.25” floppy drive.
Sorry, there was a problem. Please try again later.1 X 20+4 pin main power connector 1 X 8 pin CPU connector (4+4 so can be used where only one 4 pin connector is needed) 3 X IDE connectors 4 X SATA connectors 1 X floppy connector 1 X 8 pin PCIE connector (6+2 so can be used as a 6 pin connector) I believe 520 watts is peak power so don't plan on powering a high end graphics card though
Sorry, there was a problem. Please try again later.1- 24 pin main connector 20+4, 3- 4 pin connectors for 5.25 drives 4- SATA connectors 1- 8 pin 12V 4+4 CPU power connector 1- 6 pin PCI express 2x3 power connector 1- 8 pin 2x4 PCI express (6+2) power connector 1- floppy drive connector cable length is 15.75 in
Sorry, there was a problem. Please try again later.1 PCI-E 5x sata 2x molex 1x floppy 1x 4pin 1x 20+4
Sorry, there was a problem. Please try again later.
