Main Content

Questions & Answers

Your price for this item is $299.99
The comparable value price is $344.99
Page Showing 1-20 of 54 questions
  • QuestionCan this microwave replace a FFMV164LSA size-wise? Would I have to reinstall the back and top mounts? Thanks in advance!

    Asked by CG501.

    • Answer two things and hope this helps. 1. i made sure to check the measurements for the old and the new one. you can see in the manual and measure your existing. 2. i was able to reuse the existing mounts but again the sizes were virtually the same.

      Answered by RaulS

  • Questionreplacing a FGMV176NTF... would the mounting be the same? Pretty sure they are quite similar!

    Asked by stlrboo.

    • Answer Not a guarantee. We thought this new item should have the same mounting profile as the installed Frigidaire Gallery microwave, buy it was not identical. The newer model required the mounting plate to be an inch lower than the existing mount. If going directly onto the wall, it should not be a problem, but we had backsplash right up to the existing mounting plate. This required us to remove one inch of ceramic backsplash. That was a very dirty task and required the use of a 3 1/2 “ blade circular saw, with a diamond tip blade and an Oscillating tool with a diamond tip blade. If you have to perform this task, here are some recommendations for doing this and not crack your existing tiles. 1) Place tape directly over the area to be cut and mark you line on the tape. 2) Adjust the saw to make 1/16” deep cuts with each pass, till you are through. 3) have a second person with a spray bottle of water spray the cutting area to try and minimize the dust.

      Answered by Anonymous

  • QuestionWhat model would I replace my Frigidaire Gallery Model FGMV174KFC with?

    Asked by Timmy.

    • Answer Hi, Timmy. Thanks for reaching out to us. You can check this model: FMOS1846BS as a replacement for your previous microwave. We hope this helps. - Maria

      Answered by FrigidaireSupport

  • QuestionThe model ffmv1645ts is already discontinued, what will be the equivalent replacement which has the same mounting specs.

    Asked by Anonymous.

    • Answer Hi there, valued consumer! The Frigidaire FMOS1846BS is a suitable replacement for the discontinued FFMV1645TS over-the-range microwave, maintaining the same mounting specifications and dimensions. The Frigidaire FMOS1846BS is a direct replacement for the FFMV1645TS, offering the same mounting specifications and dimensions. Additionally, it provides enhanced features that improve functionality and aesthetics. You can confidently install the FMOS1846BS using your existing setup. - Maico

      Answered by FrigidaireSupport

  • QuestionCould this model replace FFMV1845VSA? It looks identical.

    Asked by Ineedthisstat.

    • Answer Hi there, good day! Yes, the Frigidaire FFMV1845VSA is designed to replace the FMOS1846BS model. Both are over-the-range microwaves with a capacity of 1.8 cubic feet and similar dimensions: Width: 29 7/8 inches​, Width: 29 7/8 inches​, and Depth: 15 3/4 inches. - Maico

      Answered by FrigidaireSupport

  • QuestionDoes the clock stay on at all times?

    Asked by Artzylady.

    • Answer Yes - mine does.

      Answered by Norah

  • QuestionI have model FGMV1752FA. Will this unit be a direct replacement? Thanks.

    Asked by Kevin.

    • Answer Hello, Kevin. Yes. This unit can be a replacement of your old unit, which has been discontinued, since it has a specification of Height (in): 16 3/8" Width (in): 29 7/8" Depth (in): 15 3/4", which is almost the same as model FGMV1752FA. We hope this information helps!

      Answered by FrigidaireSupport

  • QuestionDoes the Frigidaire Gallery Model’s turntable rock or go around completely?

    Asked by Anonymous.

    • Answer Hello! Thanks for reaching out! The turn table of the microwave like any other microwave spins around to help cook, defrost, or reheat evenly. Should you have any additional questions or concerns, please don't hesitate to connect with us via Live Chat or call us at 1-800-374-4432 Monday-Friday, 8:30 a.m.–8 p.m. EST, and we’ll be happy to assist. ~ Sam

      Answered by FrigidaireSupport

  • Questionis this fingerprint resistant?

    Asked by JILLM.

  • QuestionDoes the FMOS1846BS have a vent in the top front above the microwave door? thanks

    Asked by elvish.

    • Answer Hi Elvish! Thank you for asking. Yes, the Frigidaire 1.8 Cu. Ft. Over-The-Range Microwave (FMOS1846BS) has a vent grille located at the top front, above the microwave door. - Patrick

      Answered by FrigidaireSupport

  • QuestionI do not have an outside vent line. Will this model work with out one?

    Asked by CDav.

    • Answer Hi CDav, thank you for reaching out. Yes, the FMOS1846BS can be installed without an outside vent. - Reed

      Answered by FrigidaireSupport

  • QuestionWhat model would I replace my Frigidaire Gallery Model LFMV1645TF with?”

    Asked by Marco.

    • Answer Thank you for your question. The Frigidaire Gallery model LFMV1645TF has been discontinued and does not have a direct one‑for‑one replacement with the same model number. - Jessica

      Answered by FrigidaireSupport

  • QuestionIs this a direct replacement for an older model PLMV169DCC? I need it to fit exactly in the sleeve.

    Asked by Joy.

    • Answer Good day, Joy! Here’s what Frigidaire’s manuals & specs say about using the newer 1.8 cu. Ft. Over‑The‑Range Microwave with PureAir Filter as a replacement for an older Frigidaire PLMV169DCC unit: Newer Frigidaire 1.8 cu. ft. over‑the‑range microwaves (like FMOS1846/FFMV1846 series) typically measure around: - Width: ~29 7/8 in - Height: ~16 3/8 in - Depth: ~15 3/4 in (front to back) The older PLMV169DCC model was an over‑the‑range microwave of approximately: - Width: ~29 15/16 in - Height: ~16 3/8 in - Depth: ~16 15/16 in (not including door handle) Both are about the same width and height, with the new model slightly shallower front‑to‑back than the old one. That means the overall external envelope is very similar and should fit a standard 30‑inch wide opening. Bottom Line Yes, the newer 1.8 cu. ft. Over‑The‑Range Microwave with PureAir Filter has essentially the same overall size and can serve as a replacement for a PLMV169DCC in a standard 30″ opening. It is NOT guaranteed to be a direct plug‑and‑play replacement that fits exactly into the old sleeve without any modification, because older mounting brackets and hole patterns often differ. - Maico

      Answered by FrigidaireSupport

  • QuestionDoes thos model have a zero clearance door. Can it be mounted flush up against a cabinet or wall and still open the door.

    Asked by Anonymous.

    • Answer Hi there! Yes, the Frigidaire FMOS1846BW 1.8 Cu. Ft. Over-The-Range Microwave features a zero clearance door, allowing it to open fully without obstruction when installed flush against a wall or cabinet. This microwave is particularly suitable for kitchens with limited space above the range, as it can be mounted close to the wall or cabinet without hindering door operation. - Maico

      Answered by FrigidaireSupport

  • QuestionIs the duct opening at the back at the top or bottom? I need a microwave for bottom vent opening if that exists.

    Asked by Anonymous.

    • Answer The Frigidaire FMOS1846BS has its duct opening located at the top rear of the unit, which can be configured for either top (vertical) or rear (horizontal) external venting, or set up for recirculating use. This model does not have a bottom vent opening, so it wouldn’t be suitable if your installation requires venting through the bottom. - Reed

      Answered by FrigidaireSupport

  • QuestionI am replacing FGMV17WNVF. does the mounting bracket works with this model?

    Asked by bbuser1.

    • Answer Good day, Bbuser1! If you're replacing FGMV17WNVF, and you're looking at installing the Frigidaire 1.8 Cu. Ft. Over‑The‑Range Microwave with Pure Air Filter (model FMOS1846… / FMOS1846BS/… similar Pure Air series). You can use the Pure Air 1.8 cu ft Frigidaire model in place of FGMV17WNVF, as long as your cavity measurements match. However, do not expect the old mounting bracket to work. You're safest installing the OEM bracket kit designed for FGMV17-series or compatible Gallery models. That way, your drill hole placements and bracket alignment will be correct, and installation will go smoothly. - Maico

      Answered by FrigidaireSupport

  • QuestionDoes best buy install microwaves?

    Asked by Anonymous.

    • Answer Hi there, valued consumer! Yes, Best Buy does offer installation services for over-the-range microwaves, including the Frigidaire 1.8 Cu. Ft. Over-The-Range Microwave (FMOS1846BS). - Maico

      Answered by FrigidaireSupport

  • QuestionCan I vent it outside

    Asked by Anonymous.

    • Answer Hello, our valued consumer. Yes, the Frigidaire FMOS1846BS over-the-range microwave can be vented outside. We hope this answers your question. - Patrick

      Answered by FrigidaireSupport

  • QuestionDoes this microwave have end of cycle chime as well as reminder chime?

    Asked by JOR.

    • Answer Hi there, thank you for reaching out to us regarding your inquiry. Yes, it does have an alert tone once the cycle is done. - Jessica

      Answered by FrigidaireSupport

  • QuestionWe have model LFMV1845VS which is discontinued. Is this model comparable so that the old mounting plate can be used?

    Asked by CAN.

    • Answer Hi there, our valued customer! Here are the dimensions and volume: of this model Height 16 3/8", width 29 7/8", depth 15 3/4", depth with door 90° open 39 3/8", microwave interior height 10 9/16", microwave interior width 21 9/100", microwave interior depth 14 9/16", microwave capacity 1.8 cu. Ft. -Chris

      Answered by FrigidaireSupport