“Hi as soon as I plug my washer in it comes on with a flashing sensing dill light but sounds like it is in drain mode . No dials work or water . Tried testing the same thing happened. Before this happened it would only fill with the lid open .”
Answer This Question
1-1 of 1 Answer
Hi Red- START-UP SEQUENCE: Any time the washer is being started or restarts after the washer lid has been opened and closed, the washer will turn on the cold water valve for two short periods followed by a 10 second pause before continuing. If the lid is opened during this period, the washer will pause. You will have to push the Start button again to restart the cycle. AUTOMATIC DRAIN SEQUENCE: Machine will automatically drain any time the lid is left open for more than 15 minutes and water is present. Also, machine will automatically drain if left in a paused state with the lid closed for more than 24 hours and water is present. If Fill light is on: Check your house water supply. Did you forget to turn on one or both supply valves after installation or coming back from vacation? As soon as the light starts to flash, the washer will initiate a 4 minute lockout period. The washer controls won’t respond/change during this time. After the 4 minutes, you can begin your cycle again. If you try to bypass the lock-out period by unplugging the washer, the 4 minute timer will start over again. For reference, see page 13 of the Owner's Manual: https://products.geappliances.com/MarketingObjectRetrieval/Dispatcher?RequestType=PDF&Name=49-90576-2.PDF - To reset electronics, unplug washer, wait 2 minutes, plug back in and press Start. If you need further assistance, a qualified service technician is required for an accurate diagnosis. We encourage you to contact GE Appliance Service at 1-800-432-2737 for assistance or conveniently schedule an appointment online at GEAppliances.com: https://www.geappliances.com/ge/service-and-support/service.htm?ICID=GEARsupportflyout-service - Keep in touch! Sue
Sorry, there was a problem. Please try again later.