Questions & Answers

Q: QuestionWhat is the peak power this Klipsch speaker can handle?

• A:Answer This Klipsch in-ceiling speaker can handle upto 140W peak power.

Q: QuestionWhat is the diameter of the woofer in these speakers?

• A:Answer These Klipsch speakers have a 6-1/2-inch polymer woofer.

Q: QuestionWhat is the frequency response range for this Klipsch speaker?

• A:Answer The frequency response of this speaker is 57Hz - 20kHz.

Q: QuestionHow much is the impedance of this speaker?

• A:Answer This speaker has a nominal impedance of 8 ohms.

Q: QuestionWhat type of speaker system is being used?

• A:Answer This Klipsch in-ceiling speaker uses a 2-way speaker system.

Q: QuestionCan these speakers be installed in an out door patio ceiling. They won’t be exposed to water when it rains

Asked 7 years ago by Bbb.

• A:Answer yes

  Answered 6 years ago by jamesVerified Purchase

  Helpful (4)Unhelpful (0)ReportAnswer this questionShow more answers (2)

Q: QuestionCan You use these as dolby atmos speakers

Asked 2 years ago by Rick.

• A:Answer Yes! I have 4 in ceiling for ATMOS. Keep in mind you need a receiver that can process ATMOS signals and you must have a source thay sends ATMOS to receiver. These are great ATMOS speakers so far!

  Answered 2 years ago by JessVerified Purchase

  Helpful (2)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionWhat about installing with blown-in insulation? anything extra need to be done?

Asked 8 years ago by rd.

• A:Answer Nothing additional, you just need clearance to install the speakers.

  Answered 7 years ago by zinimusprimeVerified Purchase

  Helpful (2)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionDo these have to be connected to a receiver or can you connect them directly to your tv?

Asked 7 years ago by Anonymous.

• A:Answer They need to be connected to a receiver.

  Answered 7 years ago by MotorheadrqVerified Purchase

  Helpful (2)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionIf these are installed in a ceiling that has an attic above the speakers, should an enclosure be used?

Asked 4 years ago by MattK.

• A:Answer I would. They are open frame in contrast to a Yamaha that is closed back.

  Answered 4 years ago by sdjohns

  Helpful (1)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionI am looking to buy speakers for a small restaurant. Can these speakers be compatible to SONY STRDH790 7.2 receiver?

Asked 7 months ago by PPWF.

• A:Answer The RIC-65 should be compatible with the SONY STRDH790 7.2 receiver!

  Answered 7 months ago by Klipsch Product Expert

  
  Helpful (0)Unhelpful (0)ReportAnswer this question

Q: Questionhow do you remove the covers of already installed speakers

Asked 10 months ago by Kenb.

• A:Answer The RIC-65 should use a magnetically attachable grill. You will need to pry the grill edging until the grill is removed from the face of the speaker.

  Answered 10 months ago by Klipsch Product Expert

  
  Helpful (0)Unhelpful (0)ReportAnswer this question

Q: QuestionAre these sold only in pairs? I am setting up a 7.1 system and need 7.

Asked 1 year ago by steveh1138.

• A:Answer Yes, only in pairs.

  Answered 1 year ago by TunkVerified Purchase

  Helpful (0)Unhelpful (0)ReportAnswer this question

Q: QuestionHas anyone put these in an RV? I understand they aren't made for that but im replacing in cieling speakers and found these on sale. Receiver is just the one that came with the RV itself and im replacing the wiring as the whole RV is torn apart.

Asked 2 years ago by Anonymous.

Q: QuestionI was planning on getting these to add height speakers for my 5.1 setup. I noticed they are only rated for 35 watts of continuous power. I have reference speakers that are 125 watts, and my receiver is 110 watts per channel. Will I blow these out?

Asked 3 years ago by JayP.

• A:Answer I have Reference Series as well and added these ceiling speakers for movie effects and depth. I have a Yamaha 100 watt per channel amp and have had no issues with the ceiling speakers, even at higher volumes and power levels. As all Klipsch are well made and quality speakers , I would say you would not have any problems.

  Answered 3 years ago by RandyVerified Purchase

  Helpful (1)Unhelpful (0)ReportAnswer this questionShow more answers (2)

Q: QuestionHas anyone ever tried installing them in a car?

Asked 3 years ago by Markie.

• A:Answer Not for a car

  Answered 3 years ago by ConnectedTechVerified Purchase

  Helpful (0)Unhelpful (0)ReportAnswer this question

Q: QuestionCan these be used in 5.1 set up? i mean as centre in wall mount and also rear in ceiling speakers?

Asked 4 years ago by nani.

• A:Answer You can do whatever you want as long as you match ohms and you set up properly. I am using them in 9.2. these are my height rear speakers. Nice clean finish. Highly recommend them.

  Answered 3 years ago by EngineerPhilVerified Purchase

  Helpful (0)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionDo these speakers require banana plugs to connect to the wires?

Asked 4 years ago by Anonymous.

• A:Answer Use standard speaker wire to connect the RIC-65 speaker to the AV receiver/amplifier. This speaker features spring clip terminals.

  Answered 4 years ago by Klipsch Product Expert

  
  Helpful (0)Unhelpful (0)ReportAnswer this questionShow more answers (1)

Q: QuestionWhat is the cutout diameter for each speaker?

Asked 4 years ago by Chris.

• A:Answer The required cutout for the RIC-65 is 8.3" in diameter. It will also require 4.2" of depth within the ceiling.

  Answered 4 years ago by Klipsch Product Expert

  
  Helpful (0)Unhelpful (0)ReportAnswer this question