“When the installers installed this vent hose, they ran it up then ran it back down so it basically in a half loop so it would free up room behind the dryer (so it could be pushed closer to wall) as to opposed to running it straight horizonal. Is this ok?”
Answer This Question
1-5 of 5 Answers
That is a very inefficient installation. Not only does it force your dryer to work harder to push the moist air out, but it can create a build-up of lint, which can eventually become a fire hazard. Most dryers have an indented space that allows the vent hose to be installed in a straight line without taking more than a few inches behind the dryer. When our washer was installed, the installer ran a similar loop with the drain hose so that it showed over the top of the machine, in spite of the fact that there were slots on the back of the washer for the drain hose. I asked him to move it, and he pushed it down a bit, but after he left we fixed it ourselves.
Sorry, there was a problem. Please try again later.No, it’s not ok. It’ll get clogged with lent more easily and you will need to keep checking it monthly or your clothes will not dry well.
Sorry, there was a problem. Please try again later.Make sure you clean your dryer vent and tube yearly especially with it looped.
Sorry, there was a problem. Please try again later.I believe this used to be a standard practice to do a loop. My dryer was purchased in the late 90's (Kenmore/Whirlpool), and the manual specifically illustrates how to do a loop. It also came with the same vent kit way back then, so it has the two elbows and the tubing. I am replacing it with the same kit since I'm cleaning the lint chute in the dryer. It does have quite a bit of lint built up in it, but it's been in use for 20 years. I will make a point to check it every couple of years now.
Sorry, there was a problem. Please try again later.Yes and 0 drag fits nice and neet and cant be seen from front.
Sorry, there was a problem. Please try again later.